IKA RV 10 control Instrucciones De Manejo página 14

Hose system
1
RV 10.5001 Water valve
(
Optional)
6
Silicon hose (inner dia. 6 mm)
for water
10 10
RV 10.1_10
Note: Observe "Drawings for connecting the hose system" on page 107.
RV 10 control operation
• Fit RV 10.4002 vacuum, in the bracket provided for this purpose
and connect the vacuum hose to the valve.
Connect RV 10.4002
14
2
RV 10.4002 Vacuum valve
7
Silicon hose (inner dia. 7 mm)
for water
10
RV 10.3_30
RV 10.2_20
3 4
Hose clamp Hose clamp
for silicone hose for vacuum hose
pos. 5, 6 & 7 pos. 8
8
Vacuum hose
10 10
RV 10.4_40 RV 10.5_50
RV 10 auto operation
• No additional valve is required for vacuum normal operation
with a speed-vacuum control pump. Connect the pump's vacu-
um inlet directly to the RV 10 pump hose connection.
• Connect the pump controller cable to RV 10 control.
Note: When connecting the
pump controller cable, make
sure that the snap-and-lock
plug has been inserted into the
stop position inside the pump
controller cable connection.
Connect RV 10 temperature sensor (dT)
• Connect the temperature sensor to the lower socket (dT). Al-
ways check for correct direction of the arrow.
Note: When connecting the
temperature sensor, make sure
that the snap-and-lock plug has
been inserted into the stop posi-
tion inside the temperature sen-
sor connection.
5
Silicon hose (inner dia. 5 mm)
for water
9
Connector
for water valve
10
RV 10.6_60



