Tabla de contenido
Idiomas disponibles
Idiomas disponibles
40" ELECTRIC RANGE INSTALLATION INSTRUCTIONS
2.
Power Supply Cord
Electrical Shock Hazard –Do not attempt to install
the appliance directly to a junction box, modify the
factory-installed cord, or connect a different power
cord to the appliance. If the wall outlet is not sufficient
to support the requirements of this appliance, it is the
responsibility of the consumer to have the appropriate
outlet installed by an electrician. Improper installation
and electrical connections can result in electric shock,
damage to the appliance, personal injury, fire, or death.
This appliance is equipped with a factory-connected,
4-wire power supply cord (Figure 4). This cord is rated
at 240 volts, 40 amps, and temperature rated at 194°F
(90°C). This cord is UL/CSA listed and has been tested
and approved for use with this appliance.
Figure 4: Factory connected power supply cord
Appliance Rating*
120/240 Volts 120/208 Volts Amps
8.8-16.5 kW
7.8-12.5 kW
16.6-22.5 kW
12.6-18.5 kW
* The NEC calculated load is less than the total connec-
ted load listed on the serial plate.
Power Supply Rating
Temp Rating
40 or 50 194°F (90°C)
50
194°F (90°C)
3.
Cabinet Construction
To eliminate the risk of burns or fire by
reaching over heated surface units, do not have cabinet
storage space above the range. If there is cabinet storage
space above range, reduce risk by installing a range
hood that projects horizontally a minimum of 5" (12,7 cm)
beyond the bottom of the cabinet.
Follow instructions for
the type of installation you have
Figure 5: Cabinet construction
3.1
Installation: Cabinet on Both Sides
1. If range will be installed with a cabinet on both sides,
Draw a center line on the floor between the cabinets
(Figure 5).
2. If back of range will not be flush with the wall (the
location of the outlet may not allow the range to be
positioned against the wall), draw a line on the floor
where the back edge of the range will be.
3. Install anti-tip brackets (see "Anti-Tip Bracket
Installation").
3.2
Installation: Cabinet on One Side Only
1. If range will be installed with a cabinet on one side
only, move the range into final position.
2. Draw a line on the floor along the side of the range
that is not against the cabinet. If back of range will
not be flush with the wall (the location of the outlet
may not allow the range to be positioned against the
wall), draw a line on the floor where the back edge of
the range will be.
3. Install anti-tip brackets (see "Anti-Tip Bracket
Installation").
3.3
Installation: Without Cabinet
1. If range will not be installed against a cabinet, move
range into final position.
2. Mark on the floor along both sides of the range.
If back of range will not be flush with the wall (the
location of the outlet may not allow the range to be
positioned against the wall), draw a line on the floor
where the back edge of the range will be.
3. Install anti-tip brackets (see "Anti-Tip Bracket
Installation").
7
Center
Line of
Range
Capítulos
Tabla de contenido
