Toyota HomeLink Manual Del Propietário página 6

Erase Programmed HomeLink
The HomeLink buttons can simply be
reprogrammed individually but can not be
erased individually. To erase the existing
programming from all three buttons, carry out
the following:
1) Press and hold the two outer buttons I and
III until the diode begins to flash after
approximately 20 seconds (fig. 1).
®
2) Release both buttons.
The HomeLink system is now in setting mode
(training mode) and can be reprogrammed at
any time (see steps 2 to 4 in the section
Programming).
NOTE:
As a security precaution we recommend that
you erase the programming in the HomeLink
system before selling your vehicle.
fig.1
EN
Buttons
HomeLink 5