Connections And Settings; Headphone Connection; Switching The System On - Power Dynamics PDL10-600 Live Set Manual De Instrucciones

CONNECTIONS AND SETTINGS

CHANNELS
Input 1 & 2
The two channels are fully identical. The inputs are suitable for a balanced microphone. Every
channel is fitted with a TRIM control (2) for the input sensitivity, a 3-band tone control (3, 4, 5), a
sound level control (8), an EFFECT and an AUX control (6 & 7).
Input 3 & 4
The two channels are fully identical. The inputs are suitable for a microphone or a line signal. The CD-
(LINE) connectors are located on the rear side of the mixer (22 & 23).
Every channel is fitted with a TRIM control (2) for the input sensitivity, a 3-band tone control (3, 4, 5), a
sound level control (8), an EFFECT and an AUX control (6 & 7).
ADJUSTEMENT OF THE INPUT LEVEL
Adjust the TRIM so that all channels have the same level and the PEAK LED doesn't light up. Set the
tone control to the desired level. Adjust the mix by setting the level of every channel via the individual
sound level controls (8). At last, set the overall volume (18).
AUX Connection
This output is provided for the connection of e.g. an external effect or an active monitor speaker. The
AUX control (6) determines which channel will be audible on the AUX output and at which volume.
ECHO
Every channel is fitted with an ECHO EFFECT. The EFFECT control (7) sets the balance between the
echo signal and the "clean" channel sound. The general controls REPEAT and DELAY (13 & 14) set
the desired effect.

HEADPHONE CONNECTION

Plug a stereo headphone fitted with a 6.3mm Jack plug into socket (12). Set the volume with the
control (19).

SWITCHING THE SYSTEM ON

Connect the audio sources. Set all volume controls to a minimum. Switch on the mains power of the
mixer (15) and at last switch on the amplifier.