Measuring Ac Volts; Measuring Ac Amps - Kopp GCM 221 Manual Del Propietário

Measuring AC Volts:

Note:
Voltage measurements can only be made using the test leads
and not the clamp-around jaws.
Switch the function selector to V~range. Connect red test lead
to „+" terminal and black one to the „COM" terminal. Measure
the voltage by touching the test lead tips to the circuit where
the value of voltage is needed. Read the result from the LCD
panel.

Measuring AC AMPS:

Switch the function selector to A~range. Open the jaws by
pressing the handle and insert the cable to be measured into
the jaw. Close the clamp and note the reading on the LCD.
Note:
Never clamp the Jaws around two wires as this will cause
inaccurate readings. Only clamp Jaws around a single wire
— either the HOT or NEUTRAL WIRE.
Note:
When the display is hard to read, push the hold button to
freeze the reading.
CORRECT
INCORRECT
12