Federal Signal 224XST Instrucciones De Servicio página 3

INSTALLATION AND SERVICE INSTRUCTIONS FOR FEDERAL MODEL 224XST,
SAFETY MESSAGE TO INSTALLERS, USERS AND MAINTENANCE PERSONNEL
It is important to follow all instructions shipped with this product. This device
is to be installed by a trained electrician who is thoroughly familiar with the National
Electrical Code and/or Canadian Electrical Code and will follow the NEC and/or CEC
Guidelines as well as local codes.
This device should be considered a part of the warning system and not the entire
warning system.
The selection of the mounting location for the device, its controls and the routing
of the wiring are to be accomplished under the direction of the facilities engineer and
the safety engineer. In addition, listed below are some other important safety instruc-
tions and precautions you should follow:
• Read and understand all instructions before installing or operating this
equipment.
• Never alter the unit in any manner. Safety may be compromised if ad-
ditional openings or other alterations are made to the unit.
• Do not connect this light to the system when power is on.
• After installation, ensure that the setscrew and threaded joints are prop-
erly tightened.
• Keep unit tightly closed when in operation.
• After testing is complete; provide a copy of this instruction sheet to all
operating personnel.
• Establish a procedure to routinely check the light installation for integ-
rity and proper operation.
Failure to follow all safety precautions and instructions may result in property
damage, serious injury, or death to you or others.
I. GENERAL.
The Model 224XST, 225XST and 225XST-I Strobe Lights are Visual Signaling
Devices intended for hazardous locations. The units are UL Listed Visual Signal Ap-
pliances for Hazardous Locations for indoor/outdoor use. Underwriters Laboratories
has investigated the Models 224XST, 225XST and 225XST-I to ensure that they comply
with the TYPE 4X (watertight and corrosion resistant) and IP66 (dust-tight and protec-
tion against heavy seas) enclosure requirements.
The Models 224XST and 225XST-I are available in 24VDC. The Model 225XST is
available in 12-24VDC, 120 VAC at 50/60 Hz and 230-240VAC at 50/60 Hz. The Model
224XST is also available in 120VAC at 50/60 Hz and 230-240VAC at 50/60 Hz.
II. INSTALLATION.
A. Unpacking.
After unpacking the unit, examine it for damage that may have occurred in
transit. If the equipment has been damaged, do not attempt to install or operate the
225XST AND 225XST-I
FOR USE IN HAZARDOUS LOCATIONS
-1-