Tabla de contenido
Idiomas disponibles
Idiomas disponibles
1. Plugging into the Power Supply
When you plug-in the humidifier, music will sound.
Please use the AC power supply as stated on the label. High voltage
may lead to malfunction, causing fire or electric shock.
Do not use the humidifier when the power line or plug is broken, or the
socket's gate is too loose. It may cause sparks, short-circuit or electric
shock.
Do not power on when water has leaked out or when the humidifier is
upside down. It may cause malfunction.
2. Push the "Power" Button
•
Press the "Power" button. The humidifier will begin operating
automatically
•
The display screen will show "Auto", and mist will be emitted from
the misting nozzle
•
The display screen will show the current humidity status, warm
misting mode will begin automatically
•
Ten seconds after pushing the power button, the misting amount
indicator light will flash on and off continuously (preparation for
operation)
•
At the beginning of its operation, the misting amount may be
unstable which is caused by the difference in temperature and
water quality. There will be a time delay for the atomizer to change
water into mist at a steady rate, around 10-15 minutes
•
It takes about 10-20 minutes for the mist to become warm
The temperature and humidity sensor is installed
inside the product. It will adjust to the most
appropriate humidity and begin operating
according to the room temperature (surrounding
temperature).
Misting amount during auto operation
Misting amount is adjusted automatically
according to the difference between a tested
humidity and the ideal humidity.
For initial use or repeated use after filling the
water, operation will begin automatically after
2-5 minutes. It takes this length of time for water
to flow from the tank to the slot.
Operating Methods
Warning
Warning
Warning
About Auto Operation
Surrounding humidity
<19°C
20 ~ 21°C
22 ~ 24°C
>25°C
Difference between the
most appropriate humidity
and the current humidity
>11
10 ~ 4
<3
The current humidity is
higher than the most
appropriate humidity
Push the "Mode Setup" button once. It will change to
"Sleep", "Personal Setup" and "Auto Operation" modes
respectively.
5
Power
The most appropriate
humidity ratio
65%
60%
55%
50%
Misting amount during auto
Misting amount
(operation display)
strong operation
middle operation
weak operation
stop
Tabla de contenido
