Tabla de contenido
Idiomas disponibles
Idiomas disponibles
B. SYSTEM COMPON
9081MR
MB Installation:
Step 1.
Locate the Installation marks stamped into the main frame rails located in the center of
the unit. Ref. fig. 4.
Step 2. Align and center the back of the bracket with the installation marks. Ref. figs. 4 & 5.
Step 3.
Install a flat washer on the bolt, feed the bolt through both holes of the bracket along each
side of the frame rails. Ref. fig. 5
Step 4.
Install retaining strap, flat washer and hex nut. Tighten until snug then add 1/2 turn. Ref.
fig. 5. Caution: Over tightening will cause damage to retaining strap.
Warning
: All bolts must be installed to the above procedures prior to use. Failure to install all hardware
supplied could result in serious injury or death.
N
ote: Inspect for loose or damaged components prior to use. If any damage or loose hardware is
d
etected do not use system.
Installation
Marks
In
stalling the MightEvac Retrieval Units to the 9081MRMB:
Step 1. Place the MightEvac with attached bracket to t
locati
on shown and align the bottom holes. Ref. fig. 6
Step 2. Insert the bottom pin c
the tubin of the 9081MRMB.
g
Step 3. Insert the second pin through the top installation hole of the bracket
passing under the 9081MRMB bracket ensuring the pin is completely through
both sides of the MightEvac bracket. Ref. fig. 6
Step 4. Open the pulley sheave by rotating half
on to the wheel of the pulley and close the pulley sheave.
Step
5. Ensure that cable is over the steering handles of th
under, attach the carabiner to the pulley sheave and connect to the anchorage
point. (Eyebolts) Ref. fig. 1
Disassembly: Reverse above procedures.
Warning: Both pins must only be installed at location shown. Failure to install
pins at these locations could re
Note: Ensure the unit retaining pin is ins
ENT INSTALLATION (cont.)
Fig. 4
9081MRMB
9081MRMB
Front of Unit
he 9081MRMB at the
ompletely through both the bracket and
of the sheave. Place the cable
sult in serious injury or death.
talled before using the system
7/16" Flat Washer
908
Unit
Retaining Pin
e Edge unit and not
Fig. 5
7/16" x 9" Bolt
1MRMB Bracket
Frame Rail
Retaining Strap
7/
16" Flat Washer
7/16" Hex Nut
Fig. 6
Fr
ont of Ed
ge
S
ystem
9081MRMB
Top
Ins
tallati
on
Hole
Bottom
Installation
Hole
Tabla de contenido
