2) Dry the system joints with a cloth or allow to air dry. Avoid exposure to
direct heat (e.g. from an oven or radiator).
The system joints must be cleaned promptly after coming into contact with
lubricants (e. g. grease, oil):
1) Damp a cloth with a degreasing cleaning agent (e. g. acetone or isopro
pyl alcohol).
2) Wipe down the system joints or components with the cloth.
8 Maintenance
Ottobock recommends a semi-annual inspection of the system joints to verify
functionality, check for wear and confirm the proper functioning of the com
pression springs (513D18=4.7x31-2).
Spare parts are listed in the section "Components/Design" (Compon
ents/Design).
9 Legal Information
All legal conditions are subject to the respective national laws of the country
of use and may vary accordingly.
9.1 Liability
The manufacturer will only assume liability if the product is used in accord
ance with the descriptions and instructions provided in this document. The
manufacturer will not assume liability for damage caused by disregard of this
document, particularly due to improper use or unauthorised modification of
the product.
9.2 CE Conformity
This product meets the requirements of the European Directive 93/42/EEC
for medical devices. This product has been classified as a class I device
according to the classification criteria outlined in Annex IX of the directive.
The declaration of conformity was therefore created by the manufacturer
with sole responsibility according to Annex VII of the directive.
1 Avant-propos
INFORMATION
Date de la dernière mise à jour : 2015-08-26
► Veuillez lire attentivement l'intégralité de ce document.
► Respectez les consignes de sécurité.
14 | Ottobock
Français