What If There Are Problems - baurer JBY 92 Instrucciones De Uso

14

What if there are problems?

Faults
Power LED does
not light up after
switch-on
An acoustic signal
comes from the
parent unit
The signal is weak,
the connection
keeps break-
ing up or there is
interference
30
Actions
Check whether
• the relevant power supply unit is cor-
rectly connected.
• the batteries are full or the rechargeable
battery needs charging or is damaged.
Check whether
• the maximum range has been exceeded.
• the power supply unit for the baby unit is
correctly connected.
• the baby unit is switched on.
• the batteries are full or the rechargeable
battery needs charging or is damaged.
• If another technical device such as a
microwave is in the area between the
parent and baby units, remove the device
or switch it off.
• Check whether other factors, such as
trees or anything else, are in the area
between the devices, and change the
position of the devices until the parent
unit signals a connection.
• Check whether the baby and parent units
are inside the respective receiving range.