Isotherm DR 150L Instrucciones De Uso página 15

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 31
DRAWER 150L-12V
ENGLISH
SETTING THE INSIDE TEMPERATURE
The refrigerators are provided with a manual thermostat. Turn it clockwise to lower the temperature, and
turn it counterclockwise to raise the temperature and activate the ON-OFF switch in its end position. The
knob of the thermostat is located inside the refrigerator, on the right side, as shown in Fig. 9.
Fig. 9
FILLING
Do not put hot food into the refrigerator. Place the products in a position where they do not hit each other
or break while the vehicle is moving.
Make sure the door is always well closed, and reduce opening time to a minimum.
DEFROSTING
Defrosting must be carried out when the ice layer is thicker than 4 mm.
Set the thermostat at the OFF position. While defrosting, keep food and beverages in a cool place.
Do not use any sharp metal object to remove the ice or frost. Do not start the refrigerator up again until it
is completely defrosted and dry. Also empty the main tray.
CLEANING
Periodically clean the inside of the refrigerator using sodium carbonate dissolved in lukewarm water.
Avoid using abrasive products, cleaners or soaps. After cleaning, rinse with fresh water and dry with care.
When you are not using the refrigerator, clean and dry its inside to prevent mould and bad smells formation.
Warning
Do NOT wash the refrigerator drawers and parts in a dishwasher.
13
DRAWER 150L-12V_rev.04_03-2014
Tabla de contenido
loading

Productos relacionados para Isotherm DR 150L

Tabla de contenido