EBARA Press-o-Matic Instrucciones Para El Uso página 28

SETT ING OF "AUXILIAR Y CONTACT" P ARAMET ER = "2" – Remote on/off control function
When the "AUXILIAR Y CON TACT" p arameter is
set on "2" the Press•o•Matic is set to be switched on
and off by remote control according to the system
requirements. This function is useful when there is the
need to programme the start of the motor pump at the
same time as o ther devices connected to one same
control unit, for example in irrigation systems where
the pump is switched on only when the irrigation
control unit activates one or more of the system's
solenoid valves. Connect the device according to the
wiring diagram shown here, bearing in mind that when
the external contact is open the Press•o•Matic shall
not start the pump e ven if the system reaches the Pmin value, while when the external contact is closed
the device shall operate according to the values set.
SETT ING OF "AUXILIAR Y CONTACT" P ARAMET ER = "3" – Second set-point
(Pmax2) function
When the "AUXILIAR Y CON TAC T" p arameter is
set on "3" the Press•o•Matic is set to adjust the
rotations of the motor pump in accordance to the
Pmax2 pressure value. This function is u seful when
the device must temporarily work at a different
pressure to the one set in the Pmax parameter, for
example if distributors requiring different pressures
are used. Connect the device according to the wiring
diagram shown here bearing in mind that when the
external contact is open the Press•o•Matic shall
adjust the pump rotations according to the Pmax
pressure value , while when the external contact is closed the device shall adjust the pump speed
according to the Pmax2 value.
ATTENTION: incorrect wiring of the auxiliary contact may cause the low voltage circuit to
short circuit wi th consequent blowi ng of the fuse! Carry out the connection with particul ar care.
28
EXTERNAL
CONTACT
EXTERNAL
CONTACT