Safety Measures; Box Content; Description And Connections - FTE Maximal SSAV 0269 Manual De Usuario

Chapter 1. Installation.

1.1. Safety measures

1.- Never place the equipment next to hot sources.
2.- Never undergo the equipment to temperatures that exceed the level of operation of the device.
3.- Do not expose the equipment to dripping or splashing.
4.- Do not place objects filled with liquids on the equipment.
5.- Respect ventilation slots of this equipment. Avoid covering them with any object.
6.- Keep clean and without obstacles a minimum radius of 40 cm around this equipment.
7.- Avoid locations with possibilities of spilling liquids on the inside of the device, and with important changes of
temperature.
8.- Never open the equipment yourself due to electric risk. In case of problems, go always to qualified technicians..
9.- Never, under no circumstances, open the equipment connected to the electrical net.
10.- During the handling it is better to disconnect the equipment of the electrical net.
11.- Respect the electricity security rules during the assembling. Use materials that obey the current law.
12.- The connecting plug must be accessible in a fast and simple way to have a fast disconnection.
13.- Never touch the plug with wet hands. Also, disconnect always the device before handling the connections..
14.- Never put any heavy object over the device, as it could get damaged.
15.- If the equipment is going to remain some time without use, it is recommendable to disconnect it from the electrical
net.
16.- The repairmen and the maintenance of the equipment must be done by TV and radio specialist technicians.

1.2. Box content

SSAV 0269

1.3. Description and connections

This modulator allows to modulate one baseband signal (audio and video) to convert it in a Band I, Band III, Band S High or
UHF channel, and combine with incoming RF channels from an installation to be distributed through coaxial cable.
The equipment has of 4 input and one output connectors . Baseband inputs - audio and video - have female RCA
connectors on the bottom side of the modulator.
RF signal coming from the antenna or cable network is indicated as RF IN and uses a female F connector.
The output, where we find mixed the incoming signals from the installation and modulated signal, is marked as RF OUT
and has a female F connector.
Installation
The equipment is provided with wedges and screws included.
The steps to make a correct installation are the followings:
Open the modulator cover
On the inside of the cover there is a plastic screwdriver in order to adjust the audio subcarrier deviation and the RF level
regulators.
If RF IN connector on the modulator is not used, connect a 75
SSAV 0269
SSAV 0269 · User's guide
User's manual
Fix the equipment to the wall with the wedged and screws
provided.
- 1 -
Plastic screwdriver
load on it.
Version_en_1.0
2 screws and plugs
FTE maximal