Homelite UT42120 Manual Del Operador página 10

ASSEMbLING THE
OPERATION
See Figure 2.
To assemble the unit for blower operation:
 Slide blower tube onto blower housing until the button
on the blower housing clicks into the slot on the tube.
 To remove, depress the button on the blower housing
and remove the tube.
 The high velocity nozzle on the end of the blower tube can
be removed to allow a larger area to be covered during
blower operation. To remove, lift the flap and slide the
nozzle off. To reinstall, slide nozzle on tube until the tab
on the blower tube snaps into the slot on nozzle flap.
ASSEMbLING THE UNIT fOR vAcUUM
OPERATION
See Figures 3 - 4.
To install the vacuum bag:
 Slide the vacuum bag inlet onto blower housing until the
button on the blower housing clicks into the slot on the
bag outlet.
To install the vacuum tubes:
 Secure the upper and lower vacuum tubes together by
aligning the raised tab on the lower tube with the slot
on the upper tube. Push the tubes together until the tab
snaps securely into the slot.
 Unlock the vacuum door by pushing the door latch away
from the door.
ASSEMbLy
UNIT fOR bLOwER
Page 8 – English
wARNING:
Rotating impeller blades can cause severe injury. Always
stop the motor, unplug the power cord from the power
source, and ensure impeller blades have stopped rotating
before opening the vacuum door or installing/changing
tubes. Do not put hands or any other object into the
vacuum tubes while they are installed on the unit. Failure
to follow these instructions can result in serious personal
injury.
 Open the vacuum door and hold open with your left
hand.
 Insert the side of the vacuum tube with the ribbed tab
into the slot in the catch on the door hinge side (opposite
the door latch).
 Secure the other side of the vacuum tube by pushing it into
the slot in the door latch and closing the door latch.
 Gently let go of the vacuum door until it rests against the
vacuum tube.
To remove the vacuum tubes:
 Open the door latch.
 Remove the ribbed tab from the catch opposite the door
latch and remove tube assembly.
 Close vacuum door and secure with door latch.