Connecting The Exhaust And Venting System - LG DLE5911W Manual Del Propietário

Part 2 INITIAL STEPS FOR INSTALLING YOUR DRYER
STEP 3: Connecting the Exhaust
and Venting System.
In addition to the following warnings, please refer
to manual section on Exhaust Requirements and
Maintenance. IMPORTANT: To reduce the risk of
fire, combustion, and gas accumulation, the dryer
must be vented to the outdoors. Please follow the
following instructions (and all others in this
manual) very carefully.
• Do not use thin plastic or foil ducting.
• Use 4" (10.2 cm) diameter rigid or flexible metal
duct (note: venting materials are not supplied with
the dryer, and you should obtain the venting
materials necessary for proper installation)
• Position the dryer so that the exhaust duct is as
short as possible
• Clean old ducts before installing this dryer
• The male end of each section of exhaust duct must
point away from the dryer
• Use as few elbow joints as possible
• Use duct tape on all duct joints
• Insulate ductwork that runs through unheated
areas in order to reduce condensation and lint
build-up on pipe walls; and
• PLEASE BE AWARE THAT FAILURE TO
EXHAUST THE DRYER CORRECTLY WILL
VOID THE DRYER'S WARRANTY.
!
WARNING!
• Use a heavy metal vent.
• Do not use a plastic vent.
• Do not use a metal foil vent.
• Failure to follow these instructions can
result in death or fire.
• Clean old ducts before installing this dryer
8
I ALTERNATE EXHAUST DIRECTIONS
1
.
Remove screw & exhaust duct.
2
.
Detach and remove the bottom, left, or right
side knockout as desired.
(Right side vent not avilable on gas dryer.)
Attach
hole
3
.
Reconnect the new duct[11 in(28cm)] to the
blower housing, and Fixing the duct to the
base.
4
.
Pre-assemble 4" elbow with 4" duct.
Wrap duct tape around joint.
5
.
Insert duct assembly, elbow first, through the
side opening and connect the elbow to the
dryer internal duct.