Electrical Connections; The First Wash Cycle; Technical Data; Water Connection - Indesit IWC 71253 Instrucciones De Uso

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 49
Connecting the drain hose
should not be underwater.
! We advise against the use of hose extensions;
if it is absolutely necessary, the extension must
have the same diameter as the original hose and
must not exceed 150 cm in length.

Electrical connections

Before plugging the appliance into the electricity
socket, make sure that:
• the socket is earthed and complies with all
applicable laws;
• the socket is able to withstand the maximum
power load of the appliance as indicated in the
Technical data table (see opposite);
• the power supply voltage falls within the values
indicated in the Technical data table (see opposite);
• the socket is compatible with the plug of the
washing machine. If this is not the case, repla-
ce the socket or the plug.
! The washing machine must not be installed
outdoors, even in covered areas. It is extremely
dangerous to leave the appliance exposed to
rain, storms and other weather conditions.
! When the washing machine has been installed,
the electricity socket must be within easy reach.
Connect the drain
hose, without bending
it, to a drainage duct or
a wall drain located at a
height between 65 and
100 cm from the floor;
Alternatively, place
the drain hose over
the edge of a wa-
shbasin or bathtub,
by fastening the
guide
(which
can be purchased at
the technical assi-
stance centre) to the
tap (see figure). The
free end of the hose
! Do not use extension cords or multiple sockets.
! The cable should not be bent or compressed.
! The power supply cable must only be replaced
by authorised technicians.
Warning! The company shall not be held responsible
in the event that these regulations are not respected.

The first wash cycle

Once the appliance has been installed, and
before you use it for the first time, run a wash
cycle with detergent and no laundry, using the
wash cycle 2.

Technical data

Model
IWC 71253
width 59.5 cm
Dimensions
height 85 cm
depth 51,7 cm
Capacity
from 1 to 7 kg
Electrical
please refer to the technical
data plate fixed to the machine
connections
maximum pressure
1 MPa (10 bar)
Water
minimum pressure
connection
0.05 MPa (0.5 bar)
drum capacity 46 litres
Spin speed
up to 1200 rotations per minute
Test wash
cycles in
Programme 2:
accordance
with re-
Cotton standard 60°C.
gulations
Programme 3:
1061/2010
Cotton standard 40°C.
and
1015/2010
This appliance conforms to
the following EC Directives:
- EMC 2014/30/EU (Electro-
magnetic Compatibility)
- 2012/19/EU - (WEEE)
- LVD 2014/35/EU (Low
Voltage)
GB
3

Hide quick links:

Tabla de contenido
loading

Tabla de contenido