Tabla de contenido
Idiomas disponibles
Idiomas disponibles
,&
,1_ WARNING:
You MUST make sure
the tubes are secure before using the
unit.
A_&WARNING:
Do not use the unit
without the blower tube properly attached
to avoid flying debris and/or impeller con-
tact which can cause serious injury. Al-
ways wear eye protection to prevent rocks
or debris from being blown or ricocheting
into the eyes and face which can result in
blindness or serious injury.
STOPPING YOUR UNIT
Slide the ON/OFF switch to the OFF
position.
STARTING YOUR UNIT
Your unit has two run positions, LOW
and HIGH. Slide the switch to one of
these positions to turn on the unit.
OPERATING POSITION
Eye Protection
Blower
USING
YOUR
UNIT AS A BLOWER
_IWARNING:
Inspect
the area be-
fore using the unit.
Remove
all debris
and hard objects
such as rocks, glass,
wire, etc., that can ricochet,
be thrown,
or otherwise
cause
injury
or damage
during
operation.
Use your
unit as a blower
for:
• Sweeping
debrisorgrass
clippings
from
driveways,
sidewalks,
patios, etc.
• Blowing
grass
clippings,
straw,
or
leaves
into piles,
or removing
debris
from corners,
around joints, or between
bricks.
Direct air flow by directing the blower
tube down or to one side. Always
work
away from solid objects
such as walks,
large stones,
vehicles,
and fences.
Clean corners
by starting in corners
and
moving
outward.
This will help prevent
an accumulation
of debris which could
fly into your face.
Be careful when working
near plants.
The force of the air could damage
tender plants.
WARNING:
Disconnect
power
source before performing maintenance.
GENERAL RECOMMENDATIONS
The warranty on this unit does not cover
items that have been subjected to opera-
tor abuse or negligence. To receive full
value from the warranty, the operator must
maintain unit as instructed in this manual.
Various adjustments will need to be made
periodically to properly maintain your unit.
BEFORE
EACH
USE
CHECK FOR LOOSE
FASTENERS AND PARTS
• Inlet Cover
• Blower Tube
CHECK FOR DAMAGED OR
WORN PARTS
Contact your authorized service dealer
for replacement
of damaged
or worn
parts.
• ON/OFF Switch - Ensure switch func-
tions properly by moving the switch to
the OFF position. Make sure motor
stops; then restart motor and continue.
• Inlet Cover - Discontinue use of unit if
inlet cover fails to latch properly or if it is
damaged in any way.
AFTER
EACH
USE
INSPECT AND CLEAN UNIT & LABELS
Stop unit and unplug extension cord.
• After each use, inspect complete unit
for loose or damaged parts. Clean the
unit using a damp cloth.
• Wipe off unit with a clean dry cloth.
Tabla de contenido
