Idiomas disponibles
Idiomas disponibles
Fitting the battery
1.
Remove the battery cover from the battery compartment.
2.
Insert one 9-V 6LR61 battery (not included), observing the correct
polarity.
3.
Put the battery cover back into place.
TEST mode
Since ultrasounds are inaudible to most humans, use the TEST mode to check
if your product is working properly.
1.
Place the selector in TEST position.
Hold device at an arm's length away from you and speak loudly into the
2.
microphone.
3.
If the LED flashes green and you can hear a beep sound, the product
works correctly.
How to use
The device must be positioned so that it faces the dog within the bark detection
range. For best results, place the Ultrasonic bark control below the 1.5-meter
mark, and make sure there is no high object or obstacle in the area between
the device and the dog.
The device can be placed on a flat surface, suspended or wall-mounted.
Low position: bark detection up to 5 m.
Med position: bark detection up to 10 m.
High position: bark detection up to 15 m.
Start at the lowest sensitivity setting and adjust gradually based on your dog's
reaction.
You should notice a curb in your dog's barking within the first two weeks of use.
Please note that this device does not work on deaf or hearing-impaired dogs.
