Troubleshooting - Beem Bi-Turbo Accustar Manual De Instrucciones

EN
The following table will help you locate and eliminate minor faults:
fault
The charging control
indicator (4) of the hand
vacuum cleaner does not
light up after it is put onto
the charging station.
The automatic circuit
breaker in the electrical
distribution board trips.
The appliance does not
function after pressing the
ON/OFF switch.
Vacuum performance is
inadequate.
Turbo brush does not work
NOTE!
► If you cannot resolve the problem with the steps described above, please contact
customer service.
BEEM - Elements of Lifestyle

Troubleshooting

Possible cause
Charging station power
adapter not plugged in.
Automatic circuit breaker in
electrical distribution board
tripped.
Hand vacuum cleaner was not
put into the charging station
correctly.
Too many appliances connect-
ed to the same power circuit.
No fault detected.
Battery not charged
Battery not fully charged.
Dust container (8) full up
Dust container (8) not cor-
rectly inserted.
Filter (6) is clogged.
Dust container (8) or turbo
brush not properly attached.
Bi-Turbo Accustar
Remedy
Insert plug.
Switch on the automatic
circuit breaker again.
Put the hand vacuum
cleaner correctly into the
charging station.
Reduce the number of
appliances on the power
circuit.
Contact customer
service.
Charge battery
Charge battery
Empty dust container (8)
Insert dust container (8)
correctly
Replace filter (6) as
described in the section
Replacing the filter
(page 23).
Attach dust container
and turbo brush prop-
erly, the contacts must
touch each other.
25