Mounting Of High Pressure Hose - Quipall 1500EPW Manual De Instrucciones

3.2 Mounting of high pressure hose

1. Attach the high pressure hose (7) to
the trigger gun (8) and machine.
Detach the high pressure hose by
pressing the pawl (A) or button (B)
A
B
3.3 Mounting of lance and nozzle
1. Push the lance (10) into the trigger
gun (8)
2. When inserted turn it. Caution: Make
sure the lance (10) is properly fixed
to the gun (8)
3. Attach the nozzles (11). Caution:
When attaching the nozzle (11) the
button (A) on the nozzle (11) should
come out again. Check before
activating the trigger that the
nozzle (11) is properly fixed.
A
3
7
2
1
3.4 Water connection
An ordinary 1/2" garden hose of min.
10 m and max. 25 m will be suitable.
IMPORTANT! Only use water without
any impurities. If there is a risk of sand
particles in the inlet water (i.e. from
your own well), an additional filter
should be mounted.
1. Let the water run through the
water hose before connecting it to
the machine to prevent sand and
dirt from penetrating the machine.
Note: Check that the filter is fitted
in the water inlet pipe and that it is
not clogged up.
2. Connect the water hose to the
water supply by means of the quick
connector (inlet water, max.
pressure: 10 bar, max. temperature:
40°C).
3. Turn on the water.
3.5 Start/stop of the machine
The trigger gun (8) and lance (10) is
affected by a thrust during operation -
therefore always hold it firmly with
both hands.
Plug the power cord into a grounded
120V outlet, that is on a dedicated
circuit. Do not use extension cord.
Press the reset button on the GFCI
plug adapter. This must be done each
time the unit is plugged into an
outlet.
Grounded plug/reset button
2