Bodum 5500-2 Instrucciones De Uso página 5

WARNING: Avoid spillage on the connector.
WARNING: Misuse will cause potential injury!
The heating element surface is subject to residual heat after use.
CAUTION: Do not operate the kettle on an inclined plane. Do
not operate the kettle unless the element is fully immersed.
Do not move while the kettle is switched on.
INSTALLATION
• Place the appliance on a stable flat surface which is neither
hot nor near a heat source. The surface must be dry. Keep the
appliance and its mains cable out of reach of children.
• During use, do not place the base unit on a metal tray or a
metal surface.
• Ensure that the voltage indicated on the rating plate of
the appliance agrees with the mains voltage in your area.
Connect the appliance only to a properly earthed power
point. (Use of a residual current device (RCD) reduces the risk
of electric shock, seek the advice of an electrician.) While the
appliance is in use, the mains plug must be accessible in case
of an emergency. To ensure continued protection against risk
of electric shock, connect to properly grounded outlets only.
• If the power point is unsuitable for accommodating the
plug of your appliance, have the power point changed by a
licensed electrician.
Retain these user instruc-
tions for future reference.
HOUSEHOLD USE ONLY
7
SPECIAL POWER-SUPPLY CORD
INSTRUCTIONS
A short power-supply cord is to be provided to reduce risks
resulting from becoming entangled in or tripping over a lon-
ger cord.
SWITCHING OFF THE KETTLE MANUALLY
The ON/OFF switch (3) can also be used to switch off the
kettle before the water boils.
SAFETY CUT-OFF
The kettle is protected against damage resulting from use
with an insufficient volume of water. A safety cut-off will
automatically disconnect the power supply if the heating
element overheats.
Should the kettle ever boil dry during operation, you must
leave it to cool for 10 minutes before re-filling it with cold
water. The safety cut-off will reset automatically once it has
cooled.
BEFORE USING Clean the kettle before using it for the first time by filling it
THE KETTLE
completely (to the MAX mark) with water, boiling the water,
and then discarding the water.
HOW TO USE THE FILLING THE WATER KETTLE
WATER KETTLE
Remove the appliance body from the base unit (4).
Open the lid (1), fill with water and close the lid again.
Do not fill the kettle with less than the MIN mark and not
more than the MAX mark, to prevent the kettle from boiling
dry or boiling water escaping from the spout.
CONNECTION TO POWER SUPPLY
After filling the kettle, position it on the base unit (4). Ensure
that the kettle body is seated correctly on the contact unit on
the base unit (4).
Connect the mains plug to the power supply and press down
the ON/OFF switch (3).
Note: Ensure that the ON/OFF switch is able to move freely.
The kettle (0.5 and 1.0L) beeps when it gets plug into power
socket. The kettle (1.5l) doesn't beep when it gets plug into
power socket.
8
EN