Tabla de contenido
Idiomas disponibles
Idiomas disponibles
2. Once theboltisloose, move ittothecenter ofthehole and
completely pull o utthebolt, i ncluding theplastic s pacer
covering thebolt.
3. Once all4 bolts areremoved discard b oltand spacers. Then
pull t hepower c ord through t heopening o ftherear p anel and
close thehole withtheattached cap.
4. Close t hebolt h oles withthe4 transport bolthole plugs.
NOTE: Ifthewasher istobetransported atalater d ate, call y our
local s ervice c enter. Toprevent suspension
andstructural
damage, yourmachine must b eproperly setupforrelocation by
acertified t echnician.
Make sure thewasher drum isempty.
1. Attach t hehose withtheredcolor i ndicator totheHot ( left)
inlet v alve. Attaching theredcoupling f irstmakes i teasier to
tighten c onnection withpliers. Screw oncoupling b yhand
until i t isseated o nthewasher.
2. Attach t hehose with theblue color i ndicator totheCold
(right) water i nlet v alve. Screw oncoupling b yhand until i t is
seated o nthewasher.
5. Attach t hehose with theblue color i ndicator tothecold water
faucet. Screw oncoupling b yhand until i tisseated o nthe
washer.
6. Using pliers, tighten t hecouplings withanadditional
two-thirds turn.
NOTE: Donotovertighten. Damage tothecoupling c an
result.
Turn onthewater faucets a nd check f orleaks.
NOTE: Replace inlet h oses a fter 5 years o fusetoreduce t he
riskofhose failure. Record h ose installation orreplacement
dates onthehoses f orfuture reference.
Periodically inspect andreplace h oses i fbulges, kinks, cuts,
wear, orleaks are found.
Proper routing o fthedrain hose protects your f loors from
damage due towater l eakage. Carefully read and follow these
instructions.
The drain hose isconnected
to your washer.
3=
4=
Using pliers, check the tightness of the hose couplings
already attached to the washer.
NOTE: Do not overtighten.
Damage to the coupling can
result.
Attach the hose with the red color indicator to the hot water
faucet. Screw on coupling by hand until it is seated on the
washer.
To prevent drain water from going back into the washer:
•
Do not straighten the drain hose, and do not force excess
drain hose into standpipe. Hose should be secure, but loose
enough to provide a gap for air.
•
Do not lay excess hose on the bottom of the laundry tub.
Floor drain
You may need additional parts. See Floor Drain under "Tools and
Parts."
Tabla de contenido
Solución de problemas
