Makita BO5020 Manual De Instrucciones página 5

ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the
tool.
Front grip
1
2
3 4
003296
Install the front grip on the tool so that its protrusions fit
into the matching notches in the front of the tool. Secure
the front grip using a screwdriver to tighten the screw
through the hole in the front grip.
Installing or removing abrasive disc
003301
CAUTION:
Always use hook-and-loop system abrasive discs.
•
Never use pressure-sensitive abrasive discs.
To install the abrasive disc, first remove all dirt or foreign
matter from the pad. Then attach the abrasive disc to the
pad, using the hook-and-loop system of the abrasive
disc and the pad. Be careful to align the holes in the
abrasive disc with those in the pad.
Installing dust bag
003322
1. Notches
2. Front grip
3. Screwdriver
4. Hole in front grip
1. Abrasive disc
1
1. Push button
2. Dust nozzle
1
2
Install the dust bag on the tool so that the arrow with
"UP" indicated on the dust nozzle points upward.
Emptying dust bag
1
2
003324
When the dust bag is about half full, switch off and
unplug the tool. Hold the tool and remove the dust bag
from the dust nozzle while pressing the push button.
1 2
003325
After emptying the dust bag, insert the hook on the dust
nozzle into the rectangular hole on one side of the dust
bag frame and push up the dust bag frame until it clicks
into place on the push button.
003327
5
1. Dust nozzle
2. Push button
1. Hook
2. Dust nozzle
3. Push button
4. Dust bag
3
4