a cloth soaked in warm water and a degreasing agent, and then dry. Do not use agents which could
scratch the surface.
•
Set the cooker on a firm and stable floor in a room that is suitable for the cooker to operate in, com-
pliant with building regulations, and then level with adjustable feet (Fig. 4).
Conditions for connection to mains:
•
Make sure that the mains voltage corresponds to the voltage indicated on the rating plate of the ap-
pliance (Fig. 5 Pos. 3)
•
To connect the appliance to the mains, connect the power cord to the terminal box on the back of the
appliance (Fig. 5 Pos. 2). The power cord with plug is NOT part of the kit and must be purcha-
sed.
•
The device must be connected to an equipotential equalization system using the equipotential screw
(Fig. 5 Pos. 1) on the back of the device. It is marked with the following symbol:
Rear panel components:
1.
Equipotential bolt
2.
Terminal box
3.
Rating plate
The power cord should be flexible, oil-resistant, earthed, polychloroprene-coated - it can be made by the
manufacturer and available from him or in specialist repair shops!
Figure 6. Connecting the unit to the mains.
Figure 4. Leveling the device
Figure 5. Rear view of unit
PE – protective wire (yellow-green)
N – neutral wire (blue)
L1, L2, L3 – phase wires (other colors)
- 18 -