Tabla de contenido
Step 5
Attaching the Horizontal Stabilizer and Rudder
1. Locate horizontal stab.
2. Carefully slide horizontal stab into fuselage, making
sure control surface horn is on top.
3. Use included strips (4 pieces) of clear tape to secure
stab to tail fillet. You should use 1 strip for top and
bottom of each side.
4. Locate rudder. Carefully snap tail wheel wire into the
clip on bottom of fuse as shown.
5. Carefully use hobby knife to slowly separate decal
from foam only where three hinges are to attach
to stab. When decal is slightly separated from the
foam, slide hinges between decals and foam of
stabilizer. Use the three pins that are supplied to
connect rudder to stab as shown. Do this by pushing
pins in carefully.
6. Install keepers on backside to secure pins
as shown.
7. Attach rudder and elevator pushrods to
respective control horns (outer holes of control horns
for both).
NOTE: It may be necessary to re-trim control
surfaces prior to flight.
Bringen Sie das Tape an
10
Step 2
Stade 2
Schritt 2
Passo 2
Paso 2
Apply Tape
Step 3
Appliquer l'adhésif
Stade 3
Schritt 3
Applicare il nastro
Aplique cinta
Passo 3
Paso 3
Step 4
Stade 4
Schritt 4
Passo 4
Paso 4
Step 5
Stade 5
Schritt 5
Passo 5
Paso 5
Step 6
Stade 6
Schritt 6
Passo 6
Paso 6
Step 7
Stade 7
Schritt 7
Passo 7
Paso 7
Tabla de contenido
