Idiomas disponibles
Idiomas disponibles
3 41 01 043 06 7 - Buch Seite 9 Mittwoch, 4. Februar 2004 11:07 11
RS 12-70 E
Operating instructions for pipe sander.
Overview.
1 Adjusting knob for speed selection
Gear setting using the electronic speed
controller.
2 Switch
For switching ON/OFF.
3 Auxiliary handle
Always work using the additional
handle.
4 Sanding belt
The sanding belt has three bearings.
The accessories described or illustrated in
these operating instructions are not neces-
sarily included in the delivery of your power
tool.
For your safety.
Before using this power tool,
read and comply with:
these operating instructions,
the enclosed safety instructions
(document number 3 41 30 054 06 1),
the relevant national industrial safety
regulations.
These operating instructions and the
enclosed safety information should be
kept carefully for later use and enclosed
with the power tool, should it be passed
on or sold.
Intended use.
This power tool is intended for:
commercial use in industry and trade,
for sanding and polishing special steel
pipes and nonferrous metals, using
dry-sanding,
to removing paint, rust and oxide film,
for applications using the sanding tool
and accessories given in these operating
instructions, or those recommended
by FEIN.
When treating metal, conductive dust can
accumulate inside the machine. In such
cases, blow out the motor space fre-
quently from outside using dry com-
pressed air and operate the power tool via
a fault-current circuit breaker (actuating
current 30 mA).
Safety instructions.
!
Risk of injury
Always work using the additional handle.
Provide for a secure stance; clamp the
material to be worked firmly.
Only set the power tool onto the work-
piece when it is switched on.
After completing the work, first raise the
power tool from the work piece and then
switch it off.
Caution! Do not touch the sanding belt
while it is running.
Only work with a sanding belt that is com-
pletely intact. Do not use any sanding belts
that are worn-out or torn.
Protect persons and combustible objects
from flying sparks.
Do not treat any materials that produce
any particles that are detrimental to health
(e. g. asbestos).
EN
9
