Nilfisk-Advance SW 655 Instrucciones De Uso página 16

ENGLISH
INTRODUCTION
This manual will help you get the most from your Nilfisk-Advance SW 655.
Read it thoroughly before operating the machine.
This product is intended for commercial use only.
PARTS AND SERVICE
Repairs, when required, should be performed by your Authorized Nilfisk-
Advance Service Center, who employs factory trained service personnel, and
maintains an inventory of Nilfisk-Advance original replacement parts and acces-
sories.
Call the NILFISK-ADVANCE DEALER named below for repair parts or service.
Please specify the Model and Serial Number when discussing your machine.
NAME PLATE
The Model Number and Serial Number of your machine are shown on the
Nameplate on the machine. This information is needed when ordering repair
parts for the machine. Use the space below to note the Model Number and Serial
Number of your machine for future reference.
MODEL NUMBER
SERIAL NUMBER
UNCRATE THE MACHINE
When the machine is delivered, carefully inspect the shipping carton and the
machine for damage. If damage is evident, save the shipping carton so that it
can be inspected. Contact the Nilfisk-Advance Customer Service Department
immediately to file a freight damage claim.
ASSEMBLY
ASSEMBLING HANDLE
1 Place ends of lower handle into holes of sweeper frame. Attach with screws
(see Figure 1).
2 Attach upper handle to lower handle using machine screws, lockwashers,
and nuts (see Figure 2).
3 Hopper handle should be attached to the dirt hopper with screws provided
(see Figure 3).
FIGURE 1
Lower Handle
Sweeper Frame
16 - FORM NO. 56041493 / SW 655
FIGURE 2
Upper Handle
FIGURE 3
Sweeper Hopper
ASSEMBLING SIDE BROOM
1 Drive belt should be positioned on the pulley when received. Check to
ensure belt is on the pulley, and between belt guides.
2 With the side arm positioned as shown in Figure 4, place the belt between
the walls of the side broom arm. Place the outside tracking belt over the
rear wheel and above the mounting bracket. The inside tracking belt must
be UNDER the mounting bracket.
3 Attach the side broom arm to the mounting bracket, by aligning the holes
in the arm with the holes in the mounting bracket. Insert clevis pins and
secure with hairpin clips.
4 Place side broom bumper on the side broom pulley with the outside flange
toward side broom. Attach side broom to the side broom pulley with
screws, lockwasher and washers.
5 Lower side broom arm and replace hopper.
6 If side broom rotates in the wrong direction, the belt is not installed
correctly.
OPERATION
MAIN BROOM
Refer to Figure 5.
1 The main broom has been preset at the factory for maximum sweeping
efficiency.
2
If adjustments are required for surfaces or wear, this can be done by
turning the adjustment knob. The height indicator will show the position of
the broom as you make your adjustment (Figure 5).
3 For best operating performance, the bristles of the broom should just touch
the floor.
NOTE: If the main broom is set too low, the sweeper will be hard to push.
Lower Handle
Hopper Handle