Kinderkraft MINK Manual De Uso página 25

5.2 Installing in vehicle
• Switch the seat handle to the car safety seat position (Figure 2, position 3), then place the
seat on the back car seat near the backrest. The seat must be placed in the rearward-facing
position (Fig. 11).
• Pull out the safety belt as much as possible. Place the lap belt over this seat and lock the car
belt buckle (Fig. 12).
• Then place the lap belt in the belt guide (M) marked in blue located on the sides of the child
seat.
• Pull the shoulder belt over the child seat through the blue belt guide on the back of the child
seat (Fig. 13).
Note: Tighten the belt up and make sure that the car safety belt has not twisted or slipped
from the guides.
• Push the baby seat to the car seat.
• Pull the lap belt horizontally to fasten it. Then, pull the shoulder belt to tighten the other
parts of the safety belt (Fig. 14).
Note: Make sure the child safety seat is fixed well and stable. Check the belt and make sure it
runs correctly.
Do not place your baby car seat too close to the car seat belt buckle (Fig. 15).
5.3 Installing the seat in stroller frame
Place the car seat on the stroller so that the child faces the stroller push handle. Before placing
the seat in the stroller, always engage the safety brake to prevent uncontrolled movement of
the stroller. Place the stroller frame adapters in the holes in the seat and push down until you
hear a "click".
Removing from the stroller: Before removing the seat, engage the safety brake in the stroller.
Release the lever on the sides of the seat (Fig. 1, part C). The seat is unlocked and can be
removed.
The seat has connectors compatible with the Maxi-Cosi® standard, so it can be mounted on
a number of stroller frames.
6.1 Removing the cover and sun protector
• Place the carrying handle in the car safety seat position (Fig. 2, position 3). Pull the plastic
part aside and move it down slightly, as shown in Figure 16.
• Release the sun protector hooks in the gap in the direction of the arrow shown in Figure 17.
Lift and remove the protector from the seat.
• Press the red button on the harness buckle (E) to release the straps.
• Remove the shoulder pads (Fig. 18) and the cushion (Fig. 19).
• Place the carrying handle in the car safety seat position (Fig. 2, position 3). Release the cover
hooks in the gap in the direction of the arrow (Fig. 20).
• Undo the hook on the edge of the cover downwards in the direction of the arrow. Release
the cover hook (Fig. 21).
• Remove the cover from the edge of the seat on both sides (Fig. 22).
25