Muting/Unmuting The Headset Microphone; Pairing The Headset To The Base Station; Restoring The Factory Settings - Sennheiser Communications VMX OFFICE Instrucciones De Uso

Muting/unmuting the headset
microphone
To mute the headset microphone:
Press and hold the volume down
button during a call until a beep is
heard in the headset.
The microphone is muted. A beep is
heard every 1.5 seconds in the head-
set.
To unmute the headset microphone:
Press and hold the volume down
button .
The beeping stops. The microphone
works as usual.
The muting is switched off
automatically when you
receive a call.
Pairing the headset to the base
station
Upon delivery, the headset and the base
station are already paired, i.e. they auto-
matically recognize each other and do
not interfere with other mobile phone or
Bluetooth devices. You do not have to
pair them again.
However, if you have to replace the
headset with a new one, e.g. because it is
damaged, the base station will not
recognize the new headset unless they
are paired as follows:
Press the program button
twice.
The base station enters pairing mode.
The PHONE LED
´
LED flash blue.
20
¾
quickly
»
and the AUX
Press and hold the volume up
button .
The headset LED
blue and red and then flashes blue,
indicating that the headset is in pair-
ing mode.
If pairing was successful:
– the headset LED
three times and
– the PHONE LED
three times.
If pairing was not successful:
– the headset LED
three times,
– the AUX LED
times.
If pairing is not successful
within 60 seconds, the
headset returns to stand-
by mode.

Restoring the factory settings

You can restore the factory settings of
the speaker volume and pairing as
follows:
Pair the headset to the base station
(see "Pairing the headset"
page 12).
All learning memory values and all
volume settings are reset to the
factory settings.
first lights up
flashes blue
»
flashes blue
flashes red
´
flashes blue three
on