Klein Tools KN1500P-EX Manual De Instrucciones página 6

ENGLISH
Rigging the Hoist for Single or Double Line Pull
1. Single Line – Only the fixed end hook should be attached to the load.
WARNING: Do NOT attach floating hook to a load for a single line pull.
WARNING: Never rig web strap in a choke position by attaching the two hooks to each other.
WARNING: Ensure sling or other device is properly seated in the bowl of the hook, and the
2. Double Line – Fixed end hook should be attached to the eye on the puller body. Floating hook should be
Reinstalling the Floating Hook
1. Insert inner bushing (long metal cylinder) into outer bushing (black nylon cylinder), and place one washer on each
side of the bushings.
2. Position washers and bushings on the inside of the hook clevis, and align all the holes.
3. Insert bolt through clevis, washers and bushings. Bolt end with hole should be visible on the other side of clevis.
4. Tighten wing nut on exposed bolt end with hole.
5. Insert straight side of cotter pin into bolt hole, until it snaps into place.
Pulling Out the Web Strap
1. To release tension on the web strap, shift ratchet switch toward the "D" on the handle.
2. Use handle to ratchet the web strap forward or off the drum.
3. For faster payout, switch the ratchet to neutral or the "N" position, disengage the pawl from the brake wheel with
one hand, and pull the web strap with the other hand.
CAUTION: When in use, leave no less than two wraps of the web strap on the drum while pulling.
CAUTION: When web strap is fully paid out, do NOT attempt to further unwind the strap. This could
result in damage to the web strap and/or brake mechanism.
Adding Tension on the Web Strap With a Load Attached:
1. Move ratchet to up or the "U" position.
2. Use the handle to ratchet the web strap upwards, or towards the "U". Continue to ratchet up until there is no longer
any slack in the strap.
Releasing Tension on the Web Strap With a Load Attached:
1. Switch the ratchet to the down or "D" position.
2. Ratchet down until you feel the tension brake release (typically after one full ratchet).
3. Once the tension brake is released, continue to ratchet down until you can safely unhook the load.
CAUTION: Do NOT unhook the load or otherwise release tension while the ratchet switch is in the up
or "U" position. Doing so will cause the brake mechanism to lock. (If locked, put tension
back on the web strap. Switch the ratchet to the down or "D" position and ratchet down
to release the tension brake).
OPERATING INSTRUCTIONS
hook latch is securely closed before pulling. Do not use the hook latch to support
any part of the load.
attached to the load.
6