Weka DK 42 B Instrucciones De Servicio página 16

Take care not to cut a water-pipe or even an electric mains. In case of doubt use a line detector
for searching the drilling area.,
6. M A I N T E N A N C E
ATTENTION: Before beginning maintenance or repair remove the mains plug from the
supply socket.
Clean the machine once the drilling work has been completed. Also clean and grease the drill bit-holding
thread.
Clean the machine with a dry or moist cleaning-rag and not with a jet of water. Make sure that no water
gets into the machine or the switch box. Ensure that the ventilation slots are always clean.
Damaged cords and plugs have to be repaired or exchanged exclusively in an authorized repair station
(www.weka-elektrowerkzeuge.de).
6.1 Oil bath gear
The gear oil should be changed after the first 100 hours of operation. Ensure that this work is carried out
in a specialist workshop, or demand on the appropriate technical documents for this work.
Clamp the machine horizontally into the vice.
Remove the three hexagon socket screws at the gear.
Take off the motor with the intermediate flange.
Change gear oil, therefore only use original gear oil (E.-Nr.: 9040001).
The required quantity is 450 ml (DK52: 400 ml).
When assembling proceed vise versa and take care that the shim ring is on the pinion shaft.
In case of doubt, ask for the technical information from us.
ATTENTION: If gear oil escapes, stop the machine immediately. Lack of oil will damage the gear.
7. G U A R A N T E E
We will guarantee the WEKA core drilling machine for 12 months from the day of delivery. During this
period we will rectify material and production defects free of charge. This warranty does not cover normal
wear and tear, overloading, non-compliance with the operating instructions and intervention by
unauthorized persons or the use of parts from other companies.
8. D E C L A R A T I O N O F C O N F O R M I T Y
Description:
Type:
from serial no.:
We hereby declare under our sole responsibility that this product conforms with the following standards:
EN60204-1, EN55014-1:2006 + A1:2009 + A2:2011, EN55014-2:1997 + Corrigendum 1997 + A1:2001
+ A2:2008, EN61000-3-2:2006 + A1:2009 + A2:2009, EN61000-3-3:2008 in accordance to the regulations
of directive 2006/42/EG, 2011/65/EU and 2004/108/EG.
WEKA Elektrowerkzeuge
Auf der Höhe 20
D 75387 Neubulach
9. R E C Y C L I N G
According to the European regulation 2002/96/EG we have to take back old machines for
departing them by substance and for recycling (see sign on name plate). Please make sure
that the old tool does not get into the unsorted municipal solid waste, but that they are given
back to us, resp. abroad to our distributors.
Diamond core drill - for drilling holes in concrete, stone and masonry
DK42B, DK52 (and versions)
0110001
Übersetzung der Originalbetriebsanleitung - Subject to change without notice 4210
Neubulach, 29.12.2012
Wilhelm Wurster, Owner
13