Biesemeyer T-Square BC30 Manual De Instrucciones página 10

IMPORTANT: If your saw fence system will be used with
a mobile base underneath the saw base and table legs,
the position of the legs will have to be changed to fit the
mobile base extension.
9. Lay the extension table upside down on a floor or
bench.
10. Position table leg (K) to the closed in corner of the
extension table (L), as shown in Fig. 19.
11. Attach the table leg (K) to the table board (L) with six
5/8" long wood screws (M). Repeat this process for
the remaining leg.
IMPORTANT: If your saw fence system will be used
with a mobile base underneath the saw base and
table legs, the position of the legs will have to be
changed to fit the mobile base extension.
12. Place table assembly (L) in position between the front
and rear rail, as shown in Fig. 20. Make sure end
of table is flush against saw table and using a bar
clamp, snug up ends of rails to hold table in position.
Using a straight edge, (N), make certain table is in the
same plane and level with saw table. Adjust leveling
screws in bottom of support legs to accomplish this.
When you are certain table is level and in the same
plane as the saw table, tighten bar clamp to hold
everything in position. Then drill 1/4" through holes
through the front and rear table frame using holes (O)
in the rail as a template. The number of holes to drill
will depend on the length of the rails.
13. After the holes have been drilled in the front and rear
table frame, fasten both front and rear rail to table Fig.
21 using the 1/4-20 x 1-1/2" long flat head screws,
fender washers and hex nuts (P) provided.
14. Lay guide tube (Q) Fig. 22, on saw table as shown,
and line up the threaded holes (R) in bottom of guide
tube with through holes (S) in the front rail. Guide
tube will extend 6" past the rail at both ends.
15. Lay guide tube on front rail and fasten the guide
tube to the front rail using the 1/4-20 x 1/2" long hex
screws and lockwashers provided. NOTE: Where
there are two holes 2-1/2" apart, use only one of the
holes.
L
10
K
M
FIG. 19
L
N
O
FIG. 20
P
FIG.21
S
FIG. 22
Q
R