Type
Model
External dimensions
Dimension of work surface
Power
Number of hot areas
Power supply
Power cord
Lid (site 2): 1 - Left hinge, 2 - Lid body, 3 - lid handle, 4 - Thermometer, 5 - Right hinge, 6 - Flue cover,
7 - Fixing bolts M5 x 12, 8 - Vent shutters of the lid
4.
INSTALLATION
•
After unpacking, check whether the unit has any visible damage. If the unit was damaged during trans-
port it should not be connected!
•
Before first use, please remove the protective film from the device. Wash the external surfaces with
a cloth soaked in warm water and a degreasing agent, and then dry. Do not use agents which could
scratch the surface.
•
The appliance should be set on a worktop or a stable, leveled base (it is recommended to use the bases
manufactured in Stalgast Radom Sp. z o.o.). If necessary, the stove can be further leveled with adjusta-
ble feet underneath the cabinet
(Fig. 7).
•
The power socket should have up-to-date measurements related to protection against electric shock.
Conditions for connection to mains:
•
Make sure that the mains voltage corresponds to the voltage indicated on the rating plate of the ap-
pliance (Fig. 8 Pos. 1)
•
To connect the appliance to the mains, connect the power cord to the terminal box on the back of the
appliance (Fig. 8 Pos. 2). The power cord with plug is NOT part of the kit and must be purcha-
sed.
•
The device must be connected to an equipotential equalization system using the equipotential screw
(Fig. 8 Pos. 3) on the back of the device. It is marked with the following symbol:
3
2
Figure 8. Back view of unit 9730100. Other devices are similarly equipped.
Technical parameters of the device
Adjustable grill hob
9730100
9730200
400x700x250
800x700x250
mm
397x560 mm
4050
1
400V, 50Hz
2
5 x 2.5 mm
Figure 7. Leveling the device
Rear panel components:
1
1.
2.
3.
- 21 -
9731100
9731190
9731200
9731290
9731300
9731390
800x700x250
mm
mm
797x560 mm
2x4050
2
2
5 x 4 mm
rating plate
terminal box
equipotential bolt
Lid
9731000
800x666x179
mm
-
-
-
-
-