TECshow HALO 7R Manual De Usuario página 6

Advanced interface
Password is "Up down up down". For the runner ,
password is "Left right left right" Touch operation:
Press one time on the "up" key (Appear the first
"*"), Then press one time on the "down" key (Ap-
pear the second "*"), Press one time on the "up"
key again (Appear the third "*") ,Press one time on
the "down" key again (Appear the fourth "*"). At last
press "OK" key to do the password authentication.
Runner operation: Turn to the left 1 bar (Appear the
first "*"), then turn to the right 1 bar (Appear the
second "*"), Turn to the left 1 bar again (Appear the
third "*" ), Turn to the right 1 bar again (Appear the
fourth "*"). At last press runner key to do the pass-
word authentication.
Option
Touch screen adjustment
Reset calibration
(Zero Calibration)
P. 6
Tecshow Halo 7R |
English version
After entering the calibration interface, Follow the cross cursor tips go
touch the corresponding position. If the four locations to the correct
data is received. Then complete the calibration and save the calibration
data. If the calibration fails, this process will continue the cycle, then
can at any time by pressing the "OK" button to interrupt calibration.
After entering the sub-interface, can be adjusted x-axis, Y-axis to the
motor's reset position. To compensate for hardware installation error.
With address code and channel value different, reset calibration not
support One-digit Two-digit Three-digit edited respectively. Not sup-
port long press too. And must be in 1 unit step-by-step calibration.
Pay attention: Don't reset calibration when the motor work. If motor
is working. Please stop it then start to reset calibration. If necessary,
please reset operation one time before reset calibration.
Instruction