Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Your new tractor has been assembled
at the factory with exception of those parts left unas-
sembled for shipping purposes.
To ensure safe and proper operation of your tractor all parts
and hardware you assemble must be tightened securely.
Use the correct tools as necessary
to ensure proper tightness,
TOOLS
REQUIRED
FOR ASSEMBLY
A socket wrench set wilt make assembly
easier. Standard wrench sizes are listed,
(2) 7/t 6" wrenches
Utility knife
(1) 1/2" wrench
Tire pressure gauge
(1) 3/4" wrench
Pliers
(1) 3/4" socket w!drive ratchet
(1) 9/I 6" wrench
Flashlight
When right or left hand is mentioned in this
manual, it meanswhen you are in the operating
position (seated behind the steering wheel).
TO
REMOVE
TRACTOR
FROM
CARTON
UNPACK
CARTON
•
Removeall accessibleloose
parts and parts
cartons from carton,
•
Cut along dotted lines on all four panels of
carton. Remove end panels and lay side
panels flat,
•
Remove mower and packing materi_s.
•
Check for any additional loose parts or
cartons and remove.
BEFORE
REMOVING
TRACTOR
FROM SKID
TO CHECK
BATTERY
1, Lift hood to raised position.
NOTE: If this battery is put into service after
month and year indicated on label (label is
located between
terminals)
charge
battery
for minimum of one hour at 6-10 amps. (See
"BA'I-FERY"
in Maintenance
section of this
manual for charging instructions).
•
For battery & battery cable installation see
"REPLACING
BATTERY" in the "Service
and Adjustments"
section in this manual,
•
Reiease lever to lock seat in position.
NOTE: You may now roll your tractor off the
skid. Follow the appropriate instruction below
to remove the tractor from the skid.
WARNING:
Before starting, read, under-
stand and follow all instructions in the Operation
section of this manual. Be sure tractor is in a
well-ventilated
area, Be sure the area in front
of tractor is clear of other people and objects.
TO ROLL TRACTOR OFF SKID (See
Operation
section
for
location
and
function
of
controls)
I,
Raise attachment
lift lever to its highest
position.
2. Release parkZng brake bydepressing
brake
pedal,
3, PEacefreewheel control in disengaged posi-
tion to disengage
transmission
(See 'q'O
TRANSPORT"
in the Operation section of
this manual).
4, Roll tractor forward off skid,
Continue with the instructions that follow.
TO INSTALL
MOWER
1. SET
PARKING
BRAKE
LEVER
AND
LOWER ATTACHMENT
LIFT LEVER
•
Depress
clutch/brake
pedal all the way
down and hold.
•
Pull parking brakelever up and hold, release
pressure
from
clutch/brake
pedal, then
release parking brake lever. Pedal should
remain in brake position, Ensure parking
brake will hold tractor secure,
TO ADJUST
SEAT
•
Sit in seat,
•
Lift up adjustment
lever (A) and slide seat
until acomfortable
position is reached which
allows you to press clutch!brake pedal all
the way down.
Tabla de contenido
