Connecting Up; Using The Comfort Indicator; Transportation And Storage; Maintenance - ProCharger LADEAMPEL Instrucciones De Montaje Y De Uso

Idiomas disponibles

5.2 | Connecting up

The ProCharger Comfort Indicator is intended to be permanently connected to the vehicle

battery. In order to connect the Comfort Indicator correctly, follow the instructions below:

1. First disconnect the motorcycle earth connection from the battery, then disconnect

the positive terminal

2. Screw the red ring terminal (positive) of the ring terminal cable to the battery's positi

ve terminal.

3. Then, screw the black ring terminal (negative) of the ring terminal cable and the mo-

torcycle's earth connection to the battery's negative terminal.

Carry out the above steps with care. It is imperative that you avoid short-circuits and

make sure the contact is secure.

The ProCharger Comfort Indicator is simply connected permanently to the battery by means

of the ring terminals. Whenever you want to check your battery's charge level, you only need

to briefly press the button on the ProCharger Comfort Indicator, and the charge level is dis-

played for 60 seconds via the three differently coloured LEDs.

• Green: (>13 V) indicates a fully charged battery

• Yellow: (12 V-13 V) means it is advisable to charge your battery

• Red:

(<12 V) means your battery is virtually flat and must be charged

The battery then does not self-discharge.

If the red or yellow LED indicates the need to charge your battery, simply connect your Pro-

Charger to the Comfort Indicator and start charging. When charging the battery, please also

follow the information provided in the instructions for use of the particular ProCharger and/

or your battery.

When transporting the ProCharger Comfort Indicator, it is best to use the original packa-

ging to provide optimal protection.

After removing the Procharger Comfort Indicator from its packaging, install it on your

motorcycle in a position where it is protected against rain and strong vibration. If you

do not intend to install it immediately, store it indoors to keep it safe from wind and we-

ather. The temperature should be between +1°C and +55°C with a max. humidity of 99%

(non-condensing).

NOTICE!

Danger of short-circuit!

Never immerse the Comfort Indicator in water or any other liquid.

Use a dampened soft cloth for surface cleaning. Do not use aggressive cleaning agents,

brushes with metal or nylon bristles, or sharp or metallic cleaning objects such as knives,

hard spatulas or similar. These can damage the surfaces.

Tabla de Contenido

10020140