Additional Safety Instructions; Noise And Vibration; Instructions For Use - MIRKA PS 1437 Instrucciones De Funcionamiento

Additional safety instructions

 The mains voltage and the voltage
specifications on the rating plate must
correspond.
 Do not press the spindle lock until the tool
stops.

Noise and vibration

The noise and vibration values have been
determined in accordance with EN 60745.
The A evaluated noise level of the power
tool is typically:
– Sound pressure level L
– Sound power level L
– Uncertainty:
Total vibration value (when polishing
painted surfaces):
– Emission value a
– Uncertainty:
CAUTION!
The indicated measurements refer to new
power tools. Daily use causes the noise and
vibration values to change.
NOTE!
The vibration emission level given in this
information sheet has been measured in
accordance with a standardised test given
in EN 60745 and may be used to compare
one tool with another. It may be used for
a preliminary assessment of exposure.
The declared vibration emission level
represents the main applications of the tool.
However if the tool is used for different
applications, with different accessories or
poorly maintained, the vibration emission
may differ. This may significantly increase
the exposure level over the total working
period.
However if the tool is used for different
applications, with different accessories or
poorly maintained, the vibration emission
may differ. This may significantly decrease
the exposure level over the total working
period.
62
: 82 dB(A);
pA
: 93 dB(A);
WA
K = 3 dB.
: 3.0 m/s
h
K = 1.5 m/s
Identify additional safety measures to
protect the operator from the effects of
vibration such as: maintain the tool and
the accessories, keep the hands warm,
organisation of work patterns.
CAUTION!
Wear ear protection at a sound pressure
above 85 dB(A).

Instructions for use

WARNING!
Before carrying out any work on the
polisher, always pull out the mains plug.
Before switching on the power tool
Unpack the polisher and check that there
are no missing or damaged parts.
Attaching the bail handle
2
2
 Push the bail handle over the gear head,
ensuring that the finger recess is face
down.
 Attach the bail handle with the 2 enclosed
screws and key (11).
NOTE!
Alternatively, the handle (3) can be attached
(on the right or left). First, remove the bail
handle.
Polisher PS 1437