Automatic Start Brewing Coffee; Pause And Serve; Setting The Clock; Indicator Lights - brim SW20 Manual De Instrucciones

Automatic start brewing coffee

1. Press MODE button twice and the PROGRAM icon will flash on the LCD screen.
2. Press SELECT button and the PROGRAM icon and the future brew time will flash. By default, the future
brew time is 12:00 AM.
3. Use the clock setting method to change the future brew time. The clock setting method can be found in
SETTING THE CLOCK section of this manual.
4. Press SELECT button to confirm the future brew time. The coffee maker will beep and the PROGRAM
icon will stay illuminated on the LCD screen.
5. When the clock reaches the future brew time, the coffee maker will brew according to the strength
selected by the user.
6. Prepare the coffee maker with the correct brewing procedures in the brewing instruction section.
NOTE: to cancel the future brew, press MODE button twice and the PROGRAM button will flash. Press
SELECT button and the PROGRAM icon will go away.
Pause and serve when brewing a 12-cup carafe only
Using the pause and serve feature: If you wish to serve a cup of coffee before the brew cycle is completed,
simply remove the carafe from the warming plate. Dripping will automatically cease. Return the carafe onto
the warming plate; dripping will resume.
CAUTION: To prevent injury when utilizing pause and serve feature, replace carafe within 30 seconds after
removing during the brewing process.
1. After approximately 2 cups of coffee have been brewed, the carafe may be slowly removed and the
coffee will stop dripping.
2. The flow valve is located on the bottom of the filter holder and is activated when the carafe is removed.
This design makes it possible for you to remove the carafe and pour a cup of coffee before the entire
carafe is brewed.
IMPORTANT: When replacing the filter holder, the flow valve must be properly inserted into the front hole
of the machine, so that it can be seen as it sits on the top of the carafe lid. (See figure 1)
3. When using this feature, make sure that the carafe is replaced under the filter holder within 30 seconds
to prevent overflow.
Auto shut off for brewing a 12-cup carafe only
2 hours after the brewing cycle has stopped the unit will automatically turn the keep warm
heating element off.

Setting the clock

By default, the clock shows 12:00 AM when plugging the power cord into 120V/60HZ power supply socket.
1. Press MODE 4 times until the clock flashes on the LCD.
2. Press HOUR button to select the hour. Press and hold hour to toggle quickly.
3. Press MIN button to select the minutes. Press and hold MIN to toggle quickly.
4. When the correct time is displayed, press Select button. The coffee maker will make an
audible beep sound.

Indicator lights

• The indicator light for brewing in the carafe mode is illuminated during the brewing process
and stays illuminated until the keep warm time is complete (2 hours).
• The indicator light for brewing in the cup/tumbler mode is illuminated during the brewing process
and shuts off once the brewing cycle is complete

Brewing a Second Carafe of Coffee

1. To brew another carafe, cup or travel tumbler of coffee. Press the "my carafe" button or "my cup" to
turn the coffee maker OFF. Remove plug from wall outlet. It is recommended that the coffee maker be
OFF and allowed to cool down between cycles.
CAUTION: Failure to allow coffee maker to cool sufficiently could cause injury to user when touching
the hot heating plate by accident and could cause hot steam and spray when the water is added to the
water reservoir. The hot steam can cause severe burns.
2. Lift the coffee maker lid. Unfold the handle, lift and remove the permanent coffee filter, discard used
coffee grounds, rinse.
3. Lift the removable filter holder up and out of the coffee maker.
4. Rinse the glass carafe or cup and removable filter holder in cool, clean water.
5. Then follow the brew coffee instructions section to brew a second carafe, cup or travel tumbler of coffee.
14