Set Contents / Accessories; Specification; Smart Sx Transmitter - Multiplex SMART SX Manual De Instrucciones

_________________________________________________________________________________________________________
•
If you notice any sign of a problem or interfer-
ence, land your model immediately, or cease op-
erations.
•
Static charge hazard!
In extremely dry air (in mountainous terrain and
on steep slopes close to weather fronts) static
charges may develop in the transmitter and / or
the pilot. Such a charge may be dissipated by a
static spark which could damage the transmitter
or cause interference, and might even endanger
the pilot. The same effects may occur when an
electrical storm is building up.
•
Counter-measures:
Cease operations as quickly as possible, walk a
little way down the mountain in order to reach a
less exposed point, and never fly in a thunder-
storm or in the vicinity of such conditions.
•
Keep well clear of mobile telephones!
As a basic rule we recommend that you switch off
mobile telephones and any other device which
could affect the pilot's concentration.
•
The SMART SX is protected against interference
from electro-magnetic fields, such as those gen-
erated by mobile telephones. The system far ex-
ceeds the legal requirements regarding inter-
ference rejection. However, the rapid develop-
ment in mobile radio, and the enormous range of
devices now in use, do represent a residual risk
which is difficult to assess. For safety's sake we
therefore recommend that you always keep at
least two metres away from any mobile telephone
which is switched on.
5. S
ET CONTENTS
The SMART SX radio control set contains the com-
ponents shown in the photo below:
•
SMART SX M-LINK transmitter
•
RX-5 light M-LINK ID 1 receiver
•
Three AA-size dry cells
•
Multi-lingual instructions
A set of optional aluminium stick tops can be fitted to
the transmitter (see Chapter 7.19). It Aluknüppel are
in black (# 7 3305) and orange (# 7 3306) available.
SMART SX
/ A
CCESSORIES
If you have acquired the transmitter together with a MUL-
TIPLEX RTF model aircraft, the set contents also include
the aeroplane, a matching flight battery and a 230 V battery
charger, as shown in the second photo.
The transmitter is available in two different stick modes
(see Chapter 7.8):
•
SMART SM M-LINK Mode 1 + 3 (# 1 5300)
•
SMART SM M-LINK Mode 2 + 4 (# 1 5301)
The following additional items are available:
•
RX-5 light M-LINK receiver
If, for example, you wish to build and equip a MULTI-
PLEX RR model, a normal kit or another model, you
will need an additional M-
LINK receiver. In this case
please note the ID number
required to match the mod-
el concerned (see Chapter
7.15).
•
USB PC lead (# 85149)
You will need a USB
adapter with Uni connector
to load a firmware update
via the port in the battery
compartment, or to transfer
new RR+ model settings into the transmitter (see
Chapter 7.18).
6. S
PECIFICATION
6.1

SMART SX transmitter

Frequency band:
Transmission type:
Aerial:
Servo channels:
Model memories:
Servo signal format:
Power supply:
Current drain:
Weight:
Dimensions (L x W x H): approx. 193 x 148 x 53 mm
Page 20
2.4 GHz
FHSS M-LINK
Integral IOAT aerial
6
50
1.5 +/- 0.55 ms (at 100% travel)
3 AA-size cells
approx. 85 mA
approx. 355 g (incl. batteries)