TERRA NOVA 4013.020 Manual De Usuario página 10

unit diagram - back panel
The overall layout on the rear of TerraNova head and combo units may vary, but the overall feature set remains the same.
Just remember that if you intend on using alternative cabinets with your combo amplifier you should first unplug the cable that connects the
internal 4 Ohm speaker, and always ensure the correct load is used with the amplifier.
1. Power Inlet: Plug your supplied power cord into your Eden amplifier using this mains inlet socket. Always ensure the power you are using is
the correct voltage as shown on the amplifier itself.
2. Power Switch: Turn the amplifier off and on using this switch.
Speaker Outputs: your amplifier or combo is fitted with 3 speaker output sockets. 2 of the sockets are 1/4" Jack sized and 1 is a Clear
Speakon type socket. Use either the single speakon (with a 4 Ohm cabinet for full power) or up to 2 sockets in combination. NEVER use all 3
sockets at the same time and always ensure your minimum total load for the entire rig is no less than 4 ohms. Your amplifier is also designed
to operate with no load, for either playing using headphones, using the amplifier in a studio, or as a preamplifier in a performance.
3. Speaker 1 out: Connect your unit to a speaker cabinet via a 1/4" Jack cable to this socket.
4. Speaker 2 out: Connect your unit to a speaker cabinet via a 1/4" Jack cable to this socket.
5. Speaker 3 out: Connect your unit to a speaker cabinet via a Speakon cable to this socket.
6. Headphone Out: Connect your headphones here using standard 3.5mm headphone cable.
7. MP3 / Line in: connect and external device using a 3.5mm jack cable here.
8. DI Ground Lift: Lift ground from your signal (when required) using this switch.
9. DI Pad: Pad the signal (reduce the output level) between line level and mic level using this switch.
10
Quick Start Guide | Terra Nova Amplifiers & Combos