HQ-Power PROMIX220U Manual Del Usuario página 4

• Always begin with the master faders, volume controls and the amplifier volume at minimum position.
Gradually turn up the volume after connection is completed.
• Use the controls with restraint. Rapid movements may damage the speakers due to amplifier clipping.
• Use the original packaging if the device is to be transported.
• Keep this manual for future reference.
4. Features
• outputs: 2 Master (XLR and RCA), 1 Rec (RCA) and booth monitor output (RCA)
• inputs: 1 Phono (RCA), 2 Line (RCA) and 1 MIC (Combi)
• trim: gain for each input channel
• peak level meter: allows the user to instantly determine the source input condition for each channel
• talk over: mutes -14dB all levels apart from the microphone
• cross fader curve: choose from two types of cross fader start-up options
• headphone monitor balance between cue and master out
• gain control with 3-fold sound control (+12/-24dB) per channel
• MIC channel 1 with 3-fold sound control (+12/-12dB), gain, cue and talk-over
• ultra high-performance headphones output, 1-way equalizer, cue-master-mix.
5. Overview
Refer to the illustrations on page 2 of this manual.
1 power switch: turn the mixer on or off.
2 POWER SUPPLY INPUT: connect to 230VAC/50Hz power source
3 Balanced master outputs: audio output signal connectors (XLR, symmetrical)
4 Master RCA output: RCA connection to an auxiliary amplifier (not included)
5 BOOTH: RCA connection for booth monitor (not included)
6 REC: RCA connection to recording device (not included)
7 CONTROL A/B: CD player inputs
8 USB: USB input
Input connectors (CH2-CH1): connect an external device (not incl., e.g. turntable, CD player...) to
9
these RCA (cinch) connectors.
10 GND (ground) connection: when buzzing occurs, connect to turntables to create earth connection.
11 PHONES OUT: plug a headphone into this jack for audio monitoring
6.35mm microphone input (microphone not incl.)
12 MIC LEVEL: adjust the microphone input level
HI/MID/LOW: microphone equalizer
Input channel controls (CH1/CH2)
Input selector switches:
• Channel 1: LINE or PHONO. Set to PHONO if a turntable (not incl.) is connected to the input;
otherwise set to LINE.
13
• Channel 2: LINE or USB. Set to USB if an input device is connected via the USB port [8]; otherwise
set to LINE.
TRIM: adjust the input signal level
HI/MID/LOW: channel equalizer
14 LED meter: indicates the master output level
TALK OVER: press this button to decrease the sound level for everything other than the main
15
microphone to 14dB. Press again to restore original status.
Headphones controls
PHONES LEVEL: adjust the output level of the headphones
16
CUE: mixing adjustment knob. Turn to the left to hear channel 1. Turn to the right to hear channel 2. At
the centre position, the levels for both channels are even.
V. 02 – 09/03/2012
PROMIX220U
4 ©Velleman nv