toolport PVC Tent + Storm set Manual De Instrucciones página 35

PROFESSIONAL CARPORT 3,30 m
GB
Instructions
Select a flat surface for the tent. Unpack the boxes and check if all listed parts are included. Remove the
slight oil film from the pipes with a cloth. In colder weather, we recommend warming up the tarpaulin to at
least 10°C before using.
Make sure that the wing nuts are always facing the inside when assembling.
Take a triangular arch (4) and connect this with the side arch (3).
1
Now Connect the arches with the roof struts (5), by using 45 mm screws (12) and the wing nuts (14).
Repeat step 1 for the next elements and place these as shown in the instructions in a row on the ground.
2
Now connect the arches through the side struts (7) and (8) with each other.
3
Make sure that in the front segment only the struts (8) are used.
Begin first assembling one side. Connect the side arch (3) with legs (1) and (2). Fix the frame with the diago-
4
nal strut (6). Fasten the diagonal strut (6) with the legs using the 75 mm screw (13) and the wing nut (14).
Secure the frame to the ground with the ground clamp (17) and ground nails (11).
Unfold the tarpaulin and pull this over the frame. Pay attention especially to the edges and corners of the
5
frame to avoid damaging the tarpaulin.
Guide the cross strut (9) into the ring in the lower end of the roof and fasten this with the fasteners (15).
6
Tighten the roof cover at the corner foot (19) with the ratchet (21).
Fasten the rear wall with the help of the elastic rings (10) to the frame. It is better to anchor the lower ends
7
of the tarpaulin with sand in order to secure it.
36