Tabla de contenido
Idiomas disponibles
Idiomas disponibles
⁄
"
1
Fig. 4a
2
⁄
"
1
Fig. 4b
4
⁄
"
1
Fig. 5a
2
GB
⁄
"
1
Fig. 5b
4
Preparation
8
⁄
"
1
2
32
33
!
38
90°
!
38
90°
5. Position the Finger Jointer until the cutter sits
approximately mid-way between the fences and refit
the MDF fence faces.
Start the router and slide the Finger Jointer forward
and backward to cut through the MDF faces. Note: It
may also trim the aluminium fences - this provides
maximum support for the MDF and will not harm the
cutter.
In use: the MDF faces will be re-cut after each new
set-up. Always position them to give maximum support
on either side of the cut.
6. Make sure the correct finger is fitted -
cutters and
⁄
" finger for
1
2
securing the finger and finger stops.
Adjust the finger to be exactly one cutter width
(
⁄
" or
⁄
") away from the cutter, toward the outer
1
1
4
2
brace end (i.e. the distance between the cutter blade
and the edge of the finger is
will assist in spacing). Tighten the nut. See Figs. 4a & b
Adjust the appropriate finger stop (
the finger and tighten the nut. For 1/2" use the stop
on the brace side and for
side of the finger. See Figs. 5a & b
In use: the finger stop provides a reference point for
finger adjustment and stores the finger position when
changing finger size. Temporarily tighten the unused
stop out of the way, until set up for use with the other
finger
7. The Initial Cut Stop (38) offsets the workpieces being
jointed. It is has a
⁄
" step on one side and a
1
4
on the other. It also determines the position of the first
finger. As a starting point set up as shown in Fig 5a &
b (as viewed from the front - switchbox end). Place the
initial cut stop onto its supports with the keys locating
in the long slots. Loosen the nuts and position the
supports, by sight, to align the edge of the initial cut
stop with the centre of the cutter (marked "!" in Fig. 5a
& b). Use a square to ensure it is 90° to the fence. Re-
adjust, as necessary, after making the practice joint.
⁄
" finger for
1
1
4
⁄
" cutters. Loosen the nuts
1
2
⁄
" or
⁄
" – a cutter shank
1
1
4
2
⁄
" or
⁄
") against
1
1
4
2
⁄
" use the stop on the slider
1
4
⁄
" step
1
2
⁄
"
4
Tabla de contenido
