Biesemeyer T-Square Manual De Instrucciones página 12

To reduce the risk of injury, turn unit off and disconnect it from power source before installing and
removing accessories, before adjusting or when making repairs. An accidental start-up can cause injury.
CONSTRUCTING EXTENSION TABLE (IF NOT SUPPLIED)
78-150T2 OR 78-130T2 RAILS ASSEMBLY
(FOR ALL OTHER SAWS)
ASSEMBLE FRONT RAIL
1. Raise saw blade (A) Fig.22. Place a straight edge (B)
against the right side of saw blade extending out over the
front of the saw as shown. Position front rail (C) against
the edge of saw table and lightly clamp in place using
bar clamps (D). Align notch (E) in front rail (C) with the
straight edge (B) as shown. NOTE: Any portion of the
notch needs to align with the straight edge. Final
calibration will be explained later.
2. Using template (F) Fig.23, check and adjust the front rail at
both sides of saw table, to make sure the horizontal portion
of front rail (C) is parallel with the table top and then
tighten bar clamps. The rail should be down from
the top of the table 2-27/32".
3. When you are certain front rail (C) is level with the table
surface, drill four 1/4" through holes into the saw table
using the 1/4" counter sunk holes in the front rail as a
template. IMPORTANT: Before drilling, check to
make certain there is no interferance such as
casting ribs behind front edge of saw table.
4. Fasten front rail (C) to saw table using the four 1/4-20 x
1-1/4" long flat head screws, flat washers, lock washers
and hex nuts supplied.
ASSEMBLY
FIG. 21
A
12
B
E
C
FIG. 22
C
FIG. 23
D
F