Control Panel - Cornwell C9200 Manual Del Usuario

2. Assemble the wheels, spacers and axle:
Slide one wheel and one spacer onto the
axle, as shown. Slide the axle through the
center holes of the feet. Place the charger
on its other side. Slide the second spacer
and the second wheel onto the
axle, with recessed hubs
facing out, as shown.
Make sure to use
the center hole.
Use a hammer
to install the
axle caps.

10. CONTROL PANEL

ON/OFF SWITCH
Use this switch to select among the
CHARGE/MAINTAIN rate, BOOST
rate, SERVICE mode and the ENGINE
START mode.
OFF – When the switch is in this position
(middle), the charger is turned off.
BOOST, CHARGE/MAINTAIN
OR SERVICE MODE – When the switch
is in this position, the Rate Selection
button can be set to either the 6A Charge/
Maintain, 55A Service Mode or the 60A
Boost setting.
ENGINE START – When the switch is in
this position, the Rate Selection button can
be set to Engine Start mode.
DIGITAL DISPLAY
The Digital Display gives a digital indication
of voltage, amperage, and battery %. It
always starts in Voltage mode, but can be
switched to a different mode by pressing
the Display button as shown below:
Boost mode or Service mode:
Voltage > OFF > Amperage...
Charge/Maintain mode:
Voltage > OFF > Battery Percentage >
Amperage...
Engine Start mode:
Voltage (No Amperes or Battery
Percentage Mode) If the process is
stopped on any mode (by pressing the
START/STOP button), the display will
show "OFF".
NOTE: When in Charge/Maintain mode,
the display will automatically go into sleep
mode (shut-off) after 2 minutes. To turn the
display back on, press any push-button.
9.2 Extend the handle from the retracted
position by pulling it upward until it locks
into place. (Press the small silver buttons
inward, if necessary.)
DISPLAY BUTTON
Use this button to set the function of the
digital display to one of the following:
(Battery %) – The digital display
shows an estimated charge percentage
of the battery connected to the charger's
battery clamps, when charging.
(Amps) – The display shows the
output current, in amps.
(Voltage) – The Digital Display shows
the voltage at the charger battery clamps,
in DC volts, while idling. The auto detection
voltage, 6 or 12, will be displayed while
boosting/charging.
START/STOP BUTTON
Use this button to start or stop the
charging or boosting process, after the
battery is properly connected and an
output or rate has been selected.
RATE SELECTION BUTTON
When in Boost, Charge/Maintain or
Service mode, use this button to select
one of the following rates:
6A Charge/Maintain
For charging small and large batteries.
60A Boost
For quickly adding energy to a severely
discharged or large capacity battery.
55A Service Mode
Maintains stable voltage at 13.6V, to
prevent battery discharge during service
or when idle in a showroom. Always use in
combination with a battery.
• 8 •