Maintenance - RIDGID R8694620 Manual Del Operador

OPERATION
HANGING/MOUNTING FLOOD LIGHT STAND
See Figures 5 - 10, pages 7 and 8.
Your stand has a variety of hanging options. Choose the
option that is best suited for your location.
NOTE: The stand can be hung in a vertical or horizontal
position.
Hanging the stand using the key holes:
 Install two screws with a center distance of 2 in.
 Place the wide portions of the key holes over the heads
of each screw.
 Slide the stand down until the screws are inside the
narrow portions of the key holes and the stand is secure.
Hanging the stand using the hooks:
 Pull the hooks completely out of their slots and rotate
them as needed.
NOTE: Hooks will not rotate until they are fully extended.
 Hang the stand from a sturdy location.

MAINTENANCE

WARNING:
When servicing, use only identical replacement
parts. Use of any other parts could create a hazard
or cause product damage.
NOTICE:
The LEDs cannot be replaced. Any attempt to
replace the LEDs may damage the floodlight.
STORING THE FLOOD LIGHT
Store indoors in a dry, locked up place—out of the reach
of children with the battery pack removed. Keep away from
corrosive agents such as garden chemicals and de-icing
salts.
NOTE: ILLUSTRATIONS START ON PAGE 7 AFTER
These products have a 90-Day Satisfaction Guarantee Policy, as well as a
For Warranty and Policy details, please go to www.RIDGID.com
FRENCH AND SPANISH LANGUAGE SECTIONS.
Three-year Limited Warranty.
or call (toll free) 1-866-539-1710.
Mounting the stand to 2x wood material using the hooks:
 Pull the hooks completely out of their slots and rotate
them upward 180 degrees.
NOTE: Hooks will not rotate until they are fully extended.
 Put the wider side of the 2x wood material on the clamping
surface of the stand. The edge of the wood should rest
against the front surface of the stand.
 Rotate the hooks down 180 degrees to clamp the stand
to the 2x wood material.
 To remove the stand from the 2x wood material, rotate
the hooks 180 degrees to the upward position.
Mounting the stand to a tripod using the tripod mounting
hole:
The flood light can be mounted to any tripod that has a
1/4-20 thread mounting screw.
 Place the stand on the tripod mounting screw. Make sure
the screw properly engages the mounting hole, on the
bottom of the stand.
 Secure the stand to the mounting screw as described in
the tripod operator's manual.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
ADJUSTING TENSION
See Figure 11, page 8.
The cradle can become loose over time. Tension between
the stand and the cradle can be increased by turning the
adjustment screw.
6 - English