Prior To Initial Operation; Know Your Product; Operation - SPARKY HeavyDuty SMD 1236CES Plus Instrucciones De Uso

Safety warnings specific for sanding
operations:
a) Do not use excessively oversized sand-
ing disc paper. follow manufacturer's
recommendations, when selecting sand-
ing paper. Larger sanding paper extending
beyond the sanding pad presents a lacera-
tion hazard and may cause snagging, tear-
ing of the disc or kickback.
Safety warnings specific for wire brush-
ing operations:
a) Be aware that wire bristles are thrown by
the brush even during ordinary opera-
tion. Do not overstress the wires by apply-
ing excessive load to the brush. The wire
bristles can easily penetrate light clothing
and/or skin.
b) If the use of a guard is recommended for
wire brushing, do not allow any interfer-
ence of the wire wheel or brush with the
guard. Wire wheel or brush may expand in
diameter due to work load and centrifugal
forces.

Know your product

Before using the power tool, familiarize your-
self with all the operating features and safety
requirements.
Use the tool and accessories only for the ap-
plications intended. All other applications are
expressly ruled out.
1. Cord with plug
2. ON/OFF switch
3. Spindle
4. Operating tool
5. Washer
6. Fastening bolt
7. Electronic regulator of speed
8. Spindle lock button

Operation

This power tool is supplied from single-phase al-
ternating current mains only. It is double insulat-
ed according to EN 60745-1 and IEC 60745 and
can be connected to grounded or not grounded
sockets. This power tool is radio suppressed in
compliance with EMC Directive.
This power tool is designed for minor finish
processing metal, plastics or wooden parts by
burnishing accessories after grinding, removing
Original instructions
patina, structuring wood and metal, etc.
This machine is appropriate for polishing,
smoothing, burnishing, texturing, brushing, de-
burring metal, wood, plastics, etc.

PRIOR TO INITIAL OPERATION

▪ Make sure the power supply voltage corre-
sponds to the value indicated on the name
plate with technical data of the tool.
▪ Always check the position of ON/OFF switch.
The power tool must be connected and dis-
connected to the power supply socket only
when this switch is in OFF position. If the plug
is connected to a receptacle while the power
switch is in the ON position, the power tool
will start operating immediately, which could
cause a serious accident.
▪ Make sure that the cord and the plug are in
order. If the replacement of the supply cord is
necessary, this has to be done by the manu-
facturer or his agent in order to avoid a safety
hazard.
WARNING: Always switch off and un-
plug the power tool prior to any adjustment,
servicing or maintenance or in case of mains
drop-out.
SWITChING ON - SWITChING Off
- Switching on: Press the rear of ON/OFF switch
2 slider, and then push it forwards until its front
side sags.
- Switching off: Press the rear lifted side ON/
OFF switch 2, and then release it to return in its
initial position.
WARNING: In case ambient tempera-
ture is lower than 0 C the machine must be
o
switched on only in "G" position of the speed
electronic regulator. After several minutes
operation at no-load the grinder can be used
also in the rest regulator positions.
Do not cover ventilation slots with hand during
operation.
ATTAChING AND REPLACING ThE AC-
CESSORIES
Place the operating tool 4 onto spindle 3 and
then add washer 5. Screw fastening bolt 6 by
Allen wrench while pressing button 8.
7
EN