Ark-One E-RIDE 11 Manual Del Usuario página 10

ENGLISH
c) C3 / Speed regulator: Briefly press
To save your selected drive settings, press the
simultaneously for 1 to 2 seconds.
* Recommendation for use: Push-starting with the foot will save the battery. Do
not hesitate to use this mode to extend your mileage!
4 - CHARGING
Your electric scooter is delivered with a specific charger.
1. To charge your electric scooter, remove the waterproof cap from the port on
the left side of the scooter deck and plug in the charger. For safety reasons,
ensure the charging port is always dry before starting to charge.
2. Plug the charger into a suitable power source.
3. When LED on the charger is red, the battery is charging.
4. When it switches to green, charging is complete. This takes approximately 4
hours. Stop charging when the diode turns green; charging the battery for
too long will reduce its lifetime.
1 2
- Only use the charger supplied with your electric scooter. Using a charger
other than that supplied will invalidate the warranty.
- To optimise the performances and lifetime of your electric scooter battery,
fully charge the battery before using it for the first time and fully charge it once
a month.
- Do not cover the battery compartment or the charger. There must be good
ventilation conditions at all times during charging.
- The charging environment must be clean. Ensure there are no traces of
damp or water in the electric socket before plugging in.
- Ensure you use a standard socket.
- Do not switch on the electronic controller during charging.
10
to start or stop the speed regulator.
and buttons again
3 4
Do not use the battery or the product in any of the cases below and contact
an Ark-One representative:
1. The battery gives off a smell or the temperature inside the appliance is too
high.
2. Leaks on the deck of the scooter.
- The battery must only be removed and changed by the Ark-One team. No
attempt should be made to dismantle the product and repair it yourself. Any
attempt to do so will invalidate the warranty.
- In case of battery leakage, do not touch it.
- Keep children away from the battery if it is leaking or displays any other
problems.
- Batteries contain dangerous substances. Under no circumstances must
any attempt be made to open the battery or to insert any solid or liquid sub-
stance into the battery or into the body of the appliance.
- Only Ark-One is authorised to repair the appliance
- Using the battery is subject to authorisation by the local authorities.
5 - USE
Before and after using your appliance: check all the connections: the brake,
the steering column quick-locking system and the wheel axles must be cor-
rectly adjusted and undamaged. Also check wheel wear.
1. The scooter is fitted with two triggers to regulate the speed. The trigger on the
right handlebar triggers acceleration when pushed downwards. The red
trigger on the left handlebar is used to brake when pushed downwards.
2. If the scooter battery is low or discharged, the appliance can be used as a
standard scooter. To do so, switch off the scooter by pressing the
for 1 or 2 seconds. Then stand on the scooter with your hands on each
handlebar and push with one foot to make it move forward. Proceed with
caution to start with.
3. A mechanical foot brake is located at the rear of the scooter. When
necessary, press it to slow down. Press gradually to avoid skidding or loss of
stability. The metal or aluminium brake may be hot after repeated braking.
Avoid touching it during and after use.
button