Rear Spacers; Door Reversibility; Operation; Control Panel - AEG AGB72526NX Manual De Instrucciones

3.4 Rear spacers

You can find the two spacers in the bag
with documentation.
1. Release the screw.
2. Engage the spacer below the screw.
3. Turn the spacer to the right position.
4. Tighten again the screws.
4
3.5 Electrical connection
• Before plugging in, ensure that the
voltage and frequency shown on the
rating plate correspond to your
domestic power supply.

4. OPERATION

4.1 Control panel

7
6
5
2
1
3
1
2
3
4
• The appliance must be earthed. The
power supply cable plug is provided
with a contact for this purpose. If the
domestic power supply socket is not
earthed, connect the appliance to a
separate earth in compliance with
current regulations, consulting a
qualified electrician.
• The manufacturer declines all
responsibility if the above safety
precautions are not observed.
• This appliance complies with the
E.E.C. Directives.

3.6 Door reversibility

In case you want to change the opening
direction of the door, contact the nearest
Authorised Service Centre. The
Authorised Service specialist will carry
out the reversibility of the doors at your
cost.
Display
1
Alarm reset button
2
OK button
3
Temperature warmer button
4
Temperature colder button
5
Mode button
6
ON/OFF button
7
It is possible to change a sound volume
of buttons by pressing together Mode
and the temperature colder buttons for a
few seconds. Change is reversible.
ENGLISH 7