Maktec MT242 Manual De Instrucciones página 5

ENGLISH
(Original instructions)
1 Base
2 Bolt holes
3 Switch trigger
4 Lock-off button
5 Spark guard
6 Screwdriver
7 Guide plate
8
Move
9 Socket wrench
10 Hex bolts
11 Clamping screw
SPECIFICATIONS
Wheel diameter
Hole diameter
No load speed (min
Dimensions (L x W x H)
Safety class
• Due to our continuing program of research and devel-
opment, the specifications herein are subject to change
without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for cutting in ferrous materials with
appropriate abrasive cut-off wheel. Follow all laws and
regulations regarding dust and work area health and
safety in your country.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.
For public low-voltage distribution systems of
between 220 V and 250 V
Switching operations of electric apparatus cause voltage
fluctuations. The operation of this device under unfavor-
able mains conditions can have adverse effects to the
operation of other equipment. With a mains impedance
equal or less than 0.28 Ohms it can be presumed that
there will be no negative effects. The mains socket used
for this device must be protected with a fuse or protective
circuit breaker having slow tripping characteristics.
Explanation of general view
12 Shaft lock
13 Cut-off wheel
14 Loosen
15 Tighten
16 O-ring
17 Inner flange
18 Ring
19 Spindle
20 Outer flange
21 Hex bolt
22 Vise plate
Model
–1
)
Net weight
General Power Tool Safety Warnings
WARNING Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or
serious injury.
ENE007-3
Save all warnings and instructions for future
reference.
ADDITIONAL SAFETY RULES FOR TOOL
1. Wear protective glasses. Also wear hearing pro-
ENF002-2
tection during extended periods of operation.
2. Use only wheels recommended by the manufac-
turer which have a maximum operating speed at
least as high as "No Load RPM" marked on the
tool's nameplate. Use only fiberglass-reinforced
cut-off wheels.
3. Check the wheel carefully for cracks or damage
before operation. Replace cracked or damaged
ENF100-1
wheel immediately.
4. Secure the wheel carefully.
5. Use only flanges specified for this tool.
6. Be careful not to damage the spindle, flanges
(especially the installing surface) or bolt, or the
wheel itself might break.
7. Keep guards in place and in working order.
8. Hold the handle firmly.
9. Keep hands away from rotating parts.
10. Make sure the wheel is not contacting the work-
piece before the switch is turned on.
23 Vise nut
24 Vise handle
25 Spacer block
26 Straight piece of wood (Spacer)
27 Over 85 mm long
28 Diameter of workpiece
29 Width of spacer block
30 Blocks
31 Limit mark
32 Brush holder cap
MT242
355 mm
25.4 mm
3,800
500 mm x 280 mm x 640 mm
17.8 kg
/II
GEA010-1
ENB066-2
5